How do you top up CVT fluid?
Top up the fluid levels through the dipstick tube, using a small funnel. Add a little at a time and check the level frequently to avoid overfilling. Use a clean funnel and fill slowly. Check the level to avoid overfilling.
How do you change the CVT in a car charger?
Install the ATF (CVT fluid) “CHANGER HOSE” to the “Charging Pipe”. Follow remaining instructions on pages TM-83 – 84.
What does CVT ” charging pipe set ” look like?
NOTE THAT THESE INSTRUCTIONS ARE CONFUSING As according to Service Manual page TM-210 piece 3 the so-called “Charging Pipe” is ALREADY installed and there may OR may not be a “CVT Fill Level Gauge (Piece 4) BUT – page TM-13 shows “Special Service Tool” — “Charging Pipe Set” and it doesn’t look like TM-210 piece 3.
How can I check the CVT fluid level?
Checking CVT Fluid Level 1. Park the vehicle on level ground (engine running, parking brake set). 2. Using a scan tool, ensure that the CVT fluid operating temperature is within the range of 170°F-180°F (77°C-82°C). 3. Shift the transmission into REVERSE for 5 seconds. 4. Shift the transmission into …
Where does CVT fluid come from on a Nissan?
MA 44 Step (2) Drain CVT fluid from CVT fluid cooler hose [outlet side (1)] and refill with NEW specified Nissan CVT fluid in the fluid CHARGING PIPE with engine running at idle speed. MA 44 Step (3) Refill until NEW CVT fluid comes out from CVT fluid cooler hose [outlet side (1)].
What to do when CVT fluid drains out?
Open the charging pipe shut-off valve and check that the CVT fluid drains out from the charging pipe. If it does not drain out, perform charging again. NOTE:Perform this work with the vehicle idling. Fill CVT fluid with the Transmission Fill Pump to the specified level.
How do you change the CVT pump plug?
1. Remove the overflow plug. 2. Install the charging pipe shut-off coupler into the overflow plug hole. Tighten the charging pipe shut-off coupler by hand. 3. Install the CVT Fill Pump changer hose to the charging pipe. Press the ATF changer hose all the way onto the charging pipe until it stops. 4.
How much CVT fluid do I need to fill the pump?
Open the charging pipe shut-off valve and fill approximately 0.5 liter (1/2 lmp qt) of the CVT fluid. 5. Close the shut-off valve and remove the CVT Fill Pump changer hose from the charging pipe. Open the charging pipe shut-off valve and check that the CVT fluid drains out from the charging pipe. If it does not drain out, perform charging again.
Checking CVT Fluid Level 1. Park the vehicle on level ground (engine running, parking brake set). 2. Using a scan tool, ensure that the CVT fluid operating temperature is within the range of 170°F-180°F (77°C-82°C). 3. Shift the transmission into REVERSE for 5 seconds. 4. Shift the transmission into