Can a diesel engine start with no spark?
Actually, you never ever want to use starting fluid on a diesel. Since a diesel uses a constant heating element (glow plugs or a heating grill on cummins), there is no way to control the ignition. On a gas motor, spark is variable and only one cylinder will fire at a time.
Why does my Nissan club have no spark?
It has no spark, the tack does not move. We changed the crank sensor, and no change. My scanner said that it should have 5 vdc on one pin of the connector and that the sensor should ohm out at 165 to 200 ohms. When I tested the plug I had 12 vdc and the sensor reads open across all the pins. Did you rebuild the motor? did it die when driving.
Why does my Nissan Altima have no spark?
I am now pushing a 2005 Altima with 2.5l because it will spin over but fails to start. No codes show on my snap-on scanner. It has no spark, the tack does not move. We changed the crank sensor, and no change. My scanner said that it should have 5 vdc on one pin of the connector and that the sensor should ohm out at 165 to 200 ohms.
It has no spark, the tack does not move. We changed the crank sensor, and no change. My scanner said that it should have 5 vdc on one pin of the connector and that the sensor should ohm out at 165 to 200 ohms. When I tested the plug I had 12 vdc and the sensor reads open across all the pins. Did you rebuild the motor? did it die when driving.
Actually, you never ever want to use starting fluid on a diesel. Since a diesel uses a constant heating element (glow plugs or a heating grill on cummins), there is no way to control the ignition. On a gas motor, spark is variable and only one cylinder will fire at a time.
I am now pushing a 2005 Altima with 2.5l because it will spin over but fails to start. No codes show on my snap-on scanner. It has no spark, the tack does not move. We changed the crank sensor, and no change. My scanner said that it should have 5 vdc on one pin of the connector and that the sensor should ohm out at 165 to 200 ohms.
Why is there no spark in my ignition?
An ignition module requires some type of external input in order to activate. If your vehicle stalls unexpectedly during operation and will not start again, it is likely because of loose or corroded electrical connections in the ignition module. In this case, check the switch, clean oxidized terminals, and replace broken wires if necessary.
Why does my Car Crank but not get fuel?
IT WILL NOT GET FUEL IN THEFT MODE , WHICH IS WHY YOH GET THE CRANK BUT NO START!!! unfortunately your car either forgot the key , or the key itself took some damage either way just have it relearn the key , put it in the on position , and leave it for 15 mins or so or get a new key and have it programmed , YW Was this answer helpful?