Does a 2009 Nissan Maxima have a timing belt or chain?
The 2009 Nissan Maxima does have a timing chain. The coolant needs to be replaced every 60,000 miles.
How much is a serpentine belt for a 2009 Nissan Maxima?
The average current price for new “2009 nissan maxima serpentine belt” is $55 from the last 212 listings.
Does a 2012 Nissan Maxima have a timing belt or chain?
The 2012 Nissan Maxima does indeed come standard equipped with a timing chain, rather than a timing belt. This is a good thing, since chains are considered sturdier and longer lasting than belts. You will still need to have the chain checked yearly, as part of routine maintenance.
Can a serpentine belt be replaced by a timing belt?
For example, select older rides may have a series of V belts in place of the serpentine belt. Some cars also have a timing belt to drive water pumps and oil pumps to the engine and other important parts. Can Sun Auto Service Replace My Serpentine Belt?
When to replace a belt due to misalignment?
Inspect and replace all accessories / pulleys that are difficult to rotate (i.e. rough/seized bearings), or show excessive wobble / free rock Warning: Any existing misalignment condition probably caused pre-mature wear of the belt ribs on the old belt. A new belt is recommended once the accessory drive has been realigned.
When do you need to replace a car belt?
Belts installed on vehicles with manual tension drives should be properly tensioned during installation, and re-tensioned after 5 minutes of run-in (30 lbs. per rib). A belt installed incorrectly will make noise and if not remedied quickly, will need to be replaced
When to replace a tensioner on a belt?
On systems equipped with an automatic tensioner, the tensioner pulley should turn freely without binding, the tensioner arm should move smoothly through its entire range of motion and there should be adequate tension. Replace the tensioner and /or pulley as required
Inspect and replace all accessories / pulleys that are difficult to rotate (i.e. rough/seized bearings), or show excessive wobble / free rock Warning: Any existing misalignment condition probably caused pre-mature wear of the belt ribs on the old belt. A new belt is recommended once the accessory drive has been realigned.
When is it time to replace your serpentine drive belt?
Check for cracks, chunks missing, abrasions, rib separation, uneven rib wear, and damaged ribs. If you notice any of these, it is time to replace your serpentine/drive belt. As soon as you notice a squealing noise, loss of power steering, the engine overheating, or the belt looks bad,…
Belts installed on vehicles with manual tension drives should be properly tensioned during installation, and re-tensioned after 5 minutes of run-in (30 lbs. per rib). A belt installed incorrectly will make noise and if not remedied quickly, will need to be replaced
When to re-tension a manual tension drive belt?
Fluid contamination on the belt (oil, power steering fluid, antifreeze, belt dressing, brake cleaner, etc.) Belts installed on vehicles with manual tension drives should be properly tensioned during installation, and re-tensioned after 5 minutes of run-in (30 lbs. per rib).