What does the p1336 Ford engine code mean?
P1336 FORD Meaning The Camshaft Position (CMP) sensor detects the position of the camshaft. The CMP sensor identifies when piston number 1 is on its compression stroke. A signal is then sent to the Powertrain Control Module (PCM) and used for synchronizing the sequential firing of the fuel injectors.
What causes a p0336 crankshaft position sensor to malfunction?
P0335 Crankshaft Position Sensor A Circuit Malfunction P0337 Crankshaft Position Sensor A Circuit Low Input P0338 Crankshaft Position Sensor A Circuit High Input P0339 Crankshaft Position Sensor A Circuit Intermittent Symptoms of a P0336 DTC may include: Potential causes of a P0336 code include:
Where is the p0335 sensor on a Nissan?
One generates a P0335 code, and one generates a P0340 code. I replaced the sensor in the back of the engine by the firewall. I did not replace the OTHER sensor on the passenger side of the engine near the fuel filter.
Where is the crankshaft sensor on a Nissan?
I bought another sensor (same part) for the passenger side (this is actually the CAMshaft sensor) to match the CRANKshaft sensor I already replaced at the back of the engine. I just drove 45 miles to work, and for the first time in a week, no stalling, no hesitation, no SES light, no codes.
What does the p1336 code on an engine mean?
P1336 Meaning. The Crankshaft Position Sensor (CKP) also known as the crank position sensor is an electronic device used in an engine to record the rate at which the crankshaft is spinning. This information is used by the Engine Control Module (ECM) to control ignition and fuel injection.
Where is the p1336 sensor on a Nissan?
The P1336 is Nissan specific which automatically triggers on when P0335 is set. You have to locate the crankshaft sensor which is just at the lower engine side along the same area of the harmonic balancer.
How does the DTC p1336 crankshaft position not learned circuit work?
DTC P1336 Crankshaft Position (CKP) System Variation Not Learned Circuit Description The Crankshaft Position (CKP) sensor sends pulses to the PCM as the reluctorwheel teeth rotate past the CKP sensor. The PCM uses the CKP pulses to synchronize the ignition and fuel injector operation, and to time the interval between each CKP pulse.
How much does it cost to diagnose a p1336 code?
The cost to diagnose the P1336 code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour. How much do you know about cars? Engine Light ON (or Service Engine Soon Warning Light)