How do you replace a clock spring on a car?
Complete the job by putting the alignment markers in place and then the steering wheel is ready to be re-installed and you are all set. Reconnect the batteries negative cable and you may need to clear the airbag trouble codes once the job is completed. Watch the Video! Here is a clock spring getting replaced along with a turn signal switch.
Can a clock spring be removed from an airbag?
This is required on some models. Gently work the clock spring back and forth and outward from the steering column shaft and gently remove. Electrical connectors are attached to the bottom of the airbag clock spring to transfer signals and controls to the steering wheel and airbag. This can also be a wiring harness on some models.
Can a clock spring be replaced on an Acura TSX?
In this video, the clock spring is replaced on a 2005 Acura TSX, but is however the same procedure as a Honda Civic, Accord, Passport, Pilot, Element, CR-V, Odyssey and Acura EL, TSX, TL, TLX, RDX, NSX and MDX. The airbag must be removed, wires disconnected and then the steering wheel must be removed.
Can a clock spring be removed from a steering column?
Use caution as not to drop the crews down inside of the steering column. The top plate may need to be moved slightly in either direction to access all of the mounting screws. Once all mounting bolts have been removed gently grasp the clock spring and pull it from the column shaft.
What do I need to replace clock spring?
The clock spring has the wiring which controls the Horn, Cruise Control, and the Radio Controls on the steering wheel. There is one special tool needed to remove the air bag. The rest are general tools. I used a TX30 star bit screwdriver which seemed just slightly small but it did get the job done.
Where does the clock spring go on a steering wheel?
4. Remove the Clock Spring: The clock spring sits over the center shaft of the steering column and is held in place by a set of small screws or plastic clips. Once the steering wheel has been removed do not rotate the clock spring upper plate.
How do you remove a clock spring from a car?
The clock spring outer plate may need to be rotated slightly to access the screws. These screws are a number 15 Torx head. Using a Torx head screwdriver or socket to remove the mounting screws by turning them counterclockwise. Use caution as not to drop the crews down inside of the steering column.
In this video, the clock spring is replaced on a 2005 Acura TSX, but is however the same procedure as a Honda Civic, Accord, Passport, Pilot, Element, CR-V, Odyssey and Acura EL, TSX, TL, TLX, RDX, NSX and MDX. The airbag must be removed, wires disconnected and then the steering wheel must be removed.