How do you install a new thermostat on a Honda Civic?
Install the new gasket onto your new thermostat. Position the new thermostat with gasket in place. The gasket will have two little rubber nubs that will line up with the holes to help locate it into place easier.
How do you replace the radiator cap on a Honda Civic?
Once the air bubbles are out of the system, replace the radiator cap. Make sure the reservoir is still full, and then allow the car to run until warm. Allow the car to run for 3 to 5 minutes while warm. Turn off the car, and allow it to cool down.
Do you flush the radiator or replace the thermostat?
Keep your car running cool with a radiator flush and a new thermostat, which will ensure that the cooling system is running at its best. Continue reading to learn how to flush the radiator and replace the thermostat on your Honda Civic.
Where is the drain bolt on a Honda Civic?
Figure 2. Engine block drain bolt location. Locate the thermostat housing. You can do so by following the upper radiator hose to the engine block. Position your drain pan as best you can under the hose, so that it can catch any fluid when you disconnect it.
Install the new gasket onto your new thermostat. Position the new thermostat with gasket in place. The gasket will have two little rubber nubs that will line up with the holes to help locate it into place easier.
What should I do if my Honda Civic overheats?
When you have confirmed that the radiator has sufficient coolant, the indication is that the thermostat is failing or has failed. A stuck thermostat causes overheating which can damage the engine, sometimes beyond repair. Buy a new thermostat at an auto parts store and replace it at home in minutes. Raise the hood of your Civic.
Where is the thermostat located on a Honda?
The thermostat is usually on the Engine Block (the big hunk of metal we usually call “the engine”). There is a top hose, and a bottom hose. Find the top hose. Start at the top of the radiator, and follow the hose back to the engine. The hose attaches to a hunk of metal which is bolted on to the engine block.
What’s the best way to install a new thermostat?
Use Hondabond or high-temp RTV silicone gasket maker once both surfaces are dry. Prepare your new thermostat using the rubber isolator, and rub the gasket maker or Honda bond until it gets tacky. Gently reinstall your new thermostat and use both 10mm bolts to secure the housings in place.
What is the thermostat number on a 1997 Honda Civic DX?
Today’s test vehicle is a 1997 Honda Civic DX and we’ll be replacing the thermostat part number 19301-PAA-306. This vehicle is equipped with the SOHC D16 engine, a 1.6 liter non-VTEC engine. Once you have the coolant drained from your engine, you can begin our how to guide on how to replace a Honda Civic thermostat.
Can a stuck thermostat cause a Honda Civic to overheat?
A stuck thermostat causes overheating which can damage the engine, sometimes beyond repair. Buy a new thermostat at an auto parts store and replace it at home in minutes. Raise the hood of your Civic. Pull the cover off the radiator. Place a drain pan beneath the radiator drain plug on the driver side of the car.