What to do if your Honda Civic cooling fan is not working?
You can briefly check if that is the issue. by removing the plug from the switch. Take a paperclip and insert one end of the paperclip in each one of the contacts. This should close the circuit and turn the fan on. Good Luck Was this answer helpful? Thanks to you both for you input. I will go check out the switch and get back to you.
How do you replace the radiator on a Honda Civic?
Be careful while applying torque load to the radiator support bolt. Before you lower the new radiator into place, attach the radiator fan shroud onto it (if applicable). Then, carefully lower radiator into place. Finally, bolt down the support bracket but don’t tighten it all the way. Figure 7. Attach fan shroud to radiator fan.
How much does it cost to replace a Honda radiator fan?
Radiator fan testing points. If the radiator fan is in working condition, move on to the next step. The ECT sensor monitors the coolant temperature, and allows the fan to turn on if the coolant is too hot. If this sensor is faulty, a replacement costs around $25 to $45.
What does the thermo switch on a Honda radiator do?
If the fan switch relay is giving off the appropriate readings and is in working condition, move on to the next step. The thermo switch (also called the cooling fan switch) sends a signal to the cooling fan, so the fan turns on if the coolant gets too hot.
You can briefly check if that is the issue. by removing the plug from the switch. Take a paperclip and insert one end of the paperclip in each one of the contacts. This should close the circuit and turn the fan on. Good Luck Was this answer helpful? Thanks to you both for you input. I will go check out the switch and get back to you.
Radiator fan testing points. If the radiator fan is in working condition, move on to the next step. The ECT sensor monitors the coolant temperature, and allows the fan to turn on if the coolant is too hot. If this sensor is faulty, a replacement costs around $25 to $45.
If the fan switch relay is giving off the appropriate readings and is in working condition, move on to the next step. The thermo switch (also called the cooling fan switch) sends a signal to the cooling fan, so the fan turns on if the coolant gets too hot.
How can I tell if my radiator fan is working?
Here is how to test if the fan is functioning properly: Unplug the radiator fan connector. Run jumper wires between the connector’s two electrical terminals. See Contact Test in Step 1. If the fan does not turn on, you will need to replace it. Figure 3. Radiator fan testing points.