How can I get the seal out of my engine cover?
Pry the seal out of the front cover using a small screwdriver or other pry tool, taking care to not distort the cover. Clean the gasket-mating surfaces of the engine cover, taking care not to score the cover, if you are reusing it.
How do you remove the cylinder head on a Toyota 2.4L?
Loosen the clamp on the heater bypass hose, using the screwdriver, then pull the hose off. Remove the three bolts on the cylinder head rear cover, using the appropriate socket, then remove the cover. Unbolt and remove the EGR valve and vacuum modulator, using the screwdriver and appropriate sockets.
How do you remove an engine from a 1997 Ford F-150?
Unbolt and remove the starter. Remove the three screws on the lower radiator air deflector, then remove the five clips and pull the deflector off. Unplug the harness connector for the air compressor. Remove the manifold-to-compressor bolts, then lift the air compressor manifold and tube assembly off the engine.
How do you replace timing cover on 4.3 car?
Coat the lips of the seal lightly with clean engine oil. Position the seal with the open end facing toward the engine. Install the seal into the cover, using the seal installer. Reinstall the crankshaft position sensor and plug it in. Tighten the oil pan bolts firmly. Lower the vehicle off the jack stands, using the floor jack.
Pry the seal out of the front cover using a small screwdriver or other pry tool, taking care to not distort the cover. Clean the gasket-mating surfaces of the engine cover, taking care not to score the cover, if you are reusing it.
Unbolt and remove the starter. Remove the three screws on the lower radiator air deflector, then remove the five clips and pull the deflector off. Unplug the harness connector for the air compressor. Remove the manifold-to-compressor bolts, then lift the air compressor manifold and tube assembly off the engine.
Coat the lips of the seal lightly with clean engine oil. Position the seal with the open end facing toward the engine. Install the seal into the cover, using the seal installer. Reinstall the crankshaft position sensor and plug it in. Tighten the oil pan bolts firmly. Lower the vehicle off the jack stands, using the floor jack.
How to replace an automotive engine front crankshaft seal?
1. Disconnect the battery Anytime you are working on the engine front there is the potential of creating short circuit if you touch a wrench or any metal piece from battery power to ground. To prevent this remove the negative cable of the battery to stop the electrical power to the car. 2. Remove the Serpentine Belt