How to do idle air volume learning in Nissan Pathfinder?
Start engine and warm it up to normal operating temperature. Check that all items listed under the topic PREPARATION (previously mentioned) are in good order. Turn ignition switch “OFF” and wait at least 10 seconds. Start the engine and let it idle for at least 30 seconds.
Why does my Nissan engine not Rev over 3000 rpm?
So a little back round first. The engine has 10hours run time on it. Everything is pretty much brand new or reman. The issue is when driving when it hits 3000 RPM its like it hit a REV limiter. when in park again like it hit a REV limiter. When starting it take longer then it should to start (about 5sec of crank).
Why does my Nissan Leaf not Rev over 3000 rpm?
The TPS is showing 0.4 Volt closed. If i check the right wires that is. (can someone confirm the wires I need to tap in to for this.) And the last thing, She is throwing a check engine code 11. I’m guessing the code is coming from start not the run cycle. since the code is the as soon as the key is turn to the “on” position
Start engine and warm it up to normal operating temperature. Check that all items listed under the topic PREPARATION (previously mentioned) are in good order. Turn ignition switch “OFF” and wait at least 10 seconds. Start the engine and let it idle for at least 30 seconds.
When to do idle air volume learning in Nissan Murano?
Each time electric throttle control actuator or ECM is replaced. Idle speed or ignition timing is out of specification. Before performing Idle Air Volume Learning, make sure that all of the following conditions are satisfied.
What’s the idle air volume learning procedure for Nissan Maxima?
Check that all items listed under the topic PREPARATION (previously mentioned) are in good order. Turn ignition switch “OFF” and wait at least 10 seconds. Start the engine and let it idle for at least 30 seconds. Disconnect throttle position sensor harness connector (brown), then reconnect it within 5 seconds. Wait 20 seconds.