How do you test a faulty speed sensor?
You can test your VSS to make sure it’s functioning properly by using a device called a multimeter. Start by disconnecting and removing the VSS from your engine so you can test it. You can then connect it to a multimeter and set the multimeter to the AC setting.
Where can I find the OBD code on a Nissan Maxima?
Nissan Corporation OBD I diagnostic page explains how to get the codes without any special tools. The codes are listed seperately for Maxima and Sentra models as needed. The codes are defined as to what system is affected. When possible we give the more commonly known OBD II component name.
How long does it take for a Nissan OBD code to appear?
For example, a code 12 will be displayed by the check engine lamp flashing 1 time for approximately 1.2 seconds, followed by a .6 second pause, then 2 short flashes. Each trouble code will be displayed 3 times before the next trouble code is displayed.
How do you find the fault code on a Nissan?
Turn the ‘diagnostic mode selector’ screw on the computer fully clockwise. The check engine light will go off. Wait 5 seconds, then turn the screw fully counter clockwise. 3. The check engine light will then begin to flash stored fault codes. The long flash (s) = 1st digit; short flashes = 2nd digit. 4.
What are the OBD codes for Nissan Sentra?
The codes are listed seperately for Maxima and Sentra models as needed. The codes are defined as to what system is affected. When possible we give the more commonly known OBD II component name.
What is the OBD code for a Nissan check engine light?
Refer to our Generic OBD II code listfor definitions on all other Nissan diagnostic trouble codes. Manufacturer Specific Codes P1105MAP/BARO Pressure Switch Solenoid Valve P1110Intake Valve Timing Control Solenoid
What is the trouble code for a 1996 Nissan?
Trouble Code Info Model Year Engine identification System 200SX 1.6L 1996-98 GA16DE Nissan EGGS 200SX 2.0L 1996-98 SR20DE Nissan ECCS 240SX 2.4L 1996-98 KA24DE Nissan ECCS 300ZX 3.0L 1996 VG30DE Nissan EGGS
Where do I find the trouble code on my Nissan?
On all models, to erase DTCs using generic scan tool (GST), select mode 4. Place diagnostic switch in the Off position. Place ignition switch in the On position. Crank engine. Start and operate engine. The trouble codes will be displayed by the flashing Engine Control Lamp and the Overheat Warning Lamp and the Overheat Warning Buzzer.
What is the diagnostic mode of a Nissan inspection lamp?
Mode IV (Switches on/off diagnosis): during this mode, the inspection lamps monitor switch on/off condition of the throttle valve switch, starter switch and vehicle speed sensor. Mode V (Real time diagnosis): if a malfunction is present during a driving test, the inspection lamps will display the malfunction condition immediately.