Why does my 94 runner run after it dies?
Fuel flow to the cold start injector was good but I had no way to check the pressure. Fuel filter was replaced at the shop and has a slight leak on the system side. If you engage the starter right before it dies, it will run for another 3 seconds.
Why does my GM Truck start then die?
He was thinking fuel pump or fuel filter. He was about to take it to a dealer to be checked out when someone told him to turn the key to the on position and leave it there until the dash lights went out then start the truck. He did this and says the truck is running fine now. It reset the security system.
Why does my car not start for 10 minutes?
… depending on the actual response.. sometimes just waiting 10 minutes would allow the car to start ok if it is the key cylinger wearing out then sometimes it just thinks that somebody is screwing around with the key cylinder and so it shuts down the starting circuit for 10 minutes to avoid a car theft
What to do if your truck starts and runs then dies?
If the problem isn’t your body control module , fuel pump, injectors, nor ignition switch. Flip over engine compartment fuse block carefully and check for bright green coloring around wire port. If any color is present use an 8mm or 10mm socket and loosen the bolt holding the wire connectors on the bottom of fuse block.
Why did my Nissan Frontier die while driving?
I just bought a 1997 Nissan frontier off a buddy. He said it died while driving. Thought it was the fuel pump but didn’t have time to mess with it. Its got a 4cylinder gas motor fuel injected. So I start it up and it will idle for 30-60 seconds and suddenly die.
What are the problems with a 2 cycle engine?
Many 2-cycle engines have problems and are sent to the junk yard before their time. Typical problems include hard starting, rough running, a need to adjust the carburetor during use to keep the engine from stalling, a need to rev the engine to keep it from dying, and not starting at all.
He was thinking fuel pump or fuel filter. He was about to take it to a dealer to be checked out when someone told him to turn the key to the on position and leave it there until the dash lights went out then start the truck. He did this and says the truck is running fine now. It reset the security system.
What to do when your 2 cycle engine stops?
Turn the engine over by hand a few times to blow the carbon granules out of the engine. Once I used our small 2-cycle garden tiller. After ten minutes the engine siezed and stopped.
Fuel flow to the cold start injector was good but I had no way to check the pressure. Fuel filter was replaced at the shop and has a slight leak on the system side. If you engage the starter right before it dies, it will run for another 3 seconds.
What causes a Toyota 4Runner to stall out?
When it asks for a lot of fuel, instead of taking off, it stalls out with the demand. This can be caused by the fuel pump or fuel filter. If your Toyota 4Runner’s engine timing is off, it’s going to stall out, misfire, and altogether not run properly.
Why does my car sputter when I Turn on the engine?
The fuel filter ‘s job is to filter the fuel going to the fuel injectors and then enter the engine. A clogged fuel filter can cause the engine to get too low fuel pressure or cause a clogged fuel injector. Low fuel pressure will cause the engine to run very leanly, and therefore it may cause the engine to sputter.
What’s the fuel pressure on a 94 runner?
I pulled the cold start fuel line off and jumped the +B to Fp. It flowed about a pint of fuel in 10 seconds from about a 3/32 port in the banjo fitting. No way to tell what the pressure was but with that much flow, I assumed it was enough to keep it running at idle. Fuel pressure spec is 38-44 psi.
When does a Toyota 4Runner ignition switch go bad?
If your Toyota 4Runner is starting right up, but then immediately dies, that is a very good indication that the ignition switch is bad. Here’s what happens. You aren’t getting power to the ignition or fuel pump while the key “rests” in the run position.
Why does my Toyota Camry engine start then stall?
Engine starts then stalls immediately… So today, I decided to clean the engine bay on the 1998 Toyota Camry V6 which I recently acquired as the car was dirty and wanted to make it a bit neater.
How is the EFI relay on a 94 runner?
Resistance readings of the VAF were within range. Voltage at the ECM was 11.5 and at the VAF was 4.99. VAF. EFI relay checked out fine. Fuel flow to the cold start injector was good but I had no way to check the pressure. Fuel filter was replaced at the shop and has a slight leak on the system side.
What happens when you turn off the fuel pump?
It sounds like every time you turn the key, it re-sets a relay/breaker/logic circuit in the fuel management system. Put a meter on your hot lead to the fuel pump. Watch to see if it shuts off before or after the engine cuts out. John