How to replace CV boots on Nissan N14 Pulsar?
One trick on stubborn axles is to have a helper hold the rotor out of the way so you can hold the axle straight to the transmission and strike it with a 3 -4 pound sand hammer to get the clip compressed into the grove and drive the axle into the splines.
What’s the problem with my Nissan Pulsar N15?
I recently replaced the starter motor in a Nissan Pulsar GA DE 16 N15-A due to a stuck solenoid. It worked fine for a short while but the problem has returned as well as another intermittent problem where no power is available to the lights and dash display after an unsuccessful attempt to start.
Where is the relay on a Nissan Pulsar?
In Pulsars that do not come with power windows, they may be wired through the harness but the relay is not included, it is the top most relay in the interior fuse panel. and may need the bottom dash panel removed to reach
What should I do if I need to replace my CV boot?
The entire steering knuckle (what the wheel, brake disk, brake caliper, and shock/spring system are mounted on) should now be free enough to pull outward. Move it out just enough to remove the axle from the splined hole. Move to the next step if only replacing the boot.
One trick on stubborn axles is to have a helper hold the rotor out of the way so you can hold the axle straight to the transmission and strike it with a 3 -4 pound sand hammer to get the clip compressed into the grove and drive the axle into the splines.
How do you replace the hub nut on a Nissan Pulsar?
Pry the wheel cover off and place the socket end of the impact wrench over the hub nut. Remove this nut setting the impact wrench to turn counterclockwise and activating the wrench until the nut comes off. Loosen the wheel lug nuts with the tire wrench, and raise the Pulsar up on jack stands using the floor jack.
How do you replace a CV nut on a pulsar?
Remove this nut setting the impact wrench to turn counterclockwise and activating the wrench until the nut comes off. Loosen the wheel lug nuts with the tire wrench, and raise the Pulsar up on jack stands using the floor jack. The jack stands should go underneath the front pinch welds of the vehicle. Then, lower the Pulsar onto the jack stands.
Where are the jack stands on a Nissan Pulsar?
The jack stands should go underneath the front pinch welds of the vehicle. Then, lower the Pulsar onto the jack stands. Finish removing the lug nuts and take the front wheels off. Starting with the driver’s side, remove the drive axle hub nut using a socket wrench or an impact wrench.