How to install front disc brake on Nissan Rogue?
Tighten to specification. Assemble the union bolt (1) and the copper washers to the brake hose and install it as an assembly to the brake caliper. Align the brake hose pin to the projection (A) by aligning it with the brake caliper hole, and tighten the union bolt (1) to the specified torque.
How big are the retainer clips on a Nissan?
Video Player is loading. This is a modal window. Replacement for Nissan selected models push-type retainer clips. Made of high quality durable nylon better than polypropylene (PP), ABS or recycled nylon. Head diameter: 20mm; stem length: 9mm and fits hole: 8mm (5/16”).
Are there clips and fasteners for Nissan Infiniti?
If you’re looking for automotive clips and fasteners for Nissan and Infiniti vehicles, you’ve come to the right place. Clips and Fasteners has everything you need, from felt washers for batteries to drain plugs for oil pans.
How do you remove a nut from a Nissan Rogue?
Remove cotter pin. Remove the nut retainer. Loosen the wheel hub lock nut from the drive shaft using power tool. Using a piece of wood and a suitable tool, tap on the lock nut to disengage the drive shaft from the wheel hub and bearing. Do not place the drive shaft joint at an extreme angle. Be careful not to over extend the slide joint.
How to remove the hub and bearing on a Nissan Rogue?
Separate drive shaft from wheel hub and bearing, Reposition the drive shaft aside with wire. Refer to FAX- 18, “Exploded View (LH)” (LH) or FAX-20, “Exploded View (RH)” (RH). Remove the wheel hub and bearing bolts using power tool. Remove the splash guard and the wheel hub and bearing from the steering knuckle.
When to replace interior trim clip on Nissan Rogue?
These are an exact fit replacement for the most used interior panel clip on 2010 Nissan Rogue SL AWD. (Likely any of the early Nissan Rogue’s, they started in 2008 if I recall correctly.)
How to remove disc brake rotor from Nissan Rogue?
CAUTION: Do not depress brake pedal while brake caliper is removed. Put alignment marks (A) on disc brake rotor and wheel hub and bearing. Remove disc brake rotor. CAUTION: Do not drop the disc brake rotor. Remove cotter pin. Remove the nut retainer. Loosen the wheel hub lock nut from the drive shaft using power tool.