What causes a Nissan Altima engine to jerk and backfire?
Be sure to check all vacuum hoses and especially the hose between the throttle body and the air breather compartment for cracks and small holes,,,Any type of outside air getting in will also cause the engine to jerk and backfire.. 9 people found this helpful. My car died the same it’s a 2006 Nissan altama.
Why does my Nissan Altima go into limp mode?
It sounds like you are having a problem with the throttle pedal position sensor and the car is going into limp mode but to be sure lets run the codes. Please let us know what happens, we are interested to see what it is. helpful? I have a very similar condition- with a 2008 Nissan Altima 2.5s Sedan.
What causes a Nissan Altima to stall out?
Fuel issues are one of the most common reasons that a vehicle would stall out, that includes your Nissan Altima. Bad gas- can cause an engine to stall out. Water in the gas tank can also cause gas to not fire properly.
Are there any problems with my 2005 Nissan Altima?
CarComplaints.com Notes: The 2005 Nissan Altima has two fairly significant problems with the floor pan rusting through & motor mounts breaking. Read more » Altima owners report that up to a basketball-size hole develops under the floor mats where the floor pan metal rusts through.
Why does my Altima not move when I press the gas pedal?
Altima QR too. Good question…..if the motor was not revving up and the car won´t move, seems the TPS at the acc pedal assembly, is faulty..but the SES light should be on. This experience was with a friend’s car of mine…
Why does my Altima go limp at high RPM?
I think mine might be the acceleration pedal sensor isn’t communicating properly with the ECM or the throttle position sensor. This theory is supported by the high rpm issue which might be the car going into “limp in mode” which is to allow the owner to drive the car to the nearest shop when accelerator issues occur.
Why does my Nissan Altima stop while driving?
I ended up taking it to the dealership. its the crankshaft sensor. I started doing a little research and it seems that a lot of people are having issues with this sensor. Its even caused some cars to just stop while driving. The sad part is that most of the stories i read resulted in having to keep taking the car back to the shop for the same part.
Is there a recall on the Nissan Altima?
Its even caused some cars to just stop while driving. The sad part is that most of the stories i read resulted in having to keep taking the car back to the shop for the same part. Its obviously a defective item but no recall. If anyone hears of a recall let me know.
What is error code for Nissan Altima mass air flow sensor?
Error Code of P0100 Mass Air Flow Sensor. Opened Air flow Inlet and their was no filament or sensor left in the Mass Air Flow Tube. Replaced with one from Junk Yard and ran perfect. The Sensor determines the Fuel/Air Mixture if no sense the car bucks, hesitates and jerks. 11 people found this helpful.