How do you take off the brake?
The car is up in the air and the tire and wheel have been removed to expose the brake rotor and caliper. To remove the brake pads, we first have to remove the caliper. Use your wrench to loosen the bolts holding the caliper in place, then remove the bolts completely (or as far as they will allow).
What should I do if I need to replace my disc brakes?
Inspect the brake hoses. If they are leaking by the fittings or damaged, they’ll need replacing — but that is outside the scope of this article. If you are only installing brake pads, skip to the step beginning: Clean the caliper slide pins below. Remove brake rotors if turning or replacing them. On most cars, the rotor is separate from the hub.
How to replace brake pads and rotors step by step?
Check out the video above or keep scrolling for general steps on how to replace brake pads and rotors in the most vehicles. Park the vehicle on a dry, flat surface and install wheel chocks. Be sure to wear safety goggles and protective gloves. Be careful when lifting the car. Use secure jack points for the jack and jack stands.
How do you take the brake pads out of a car?
Remove the two bolts which hold the brake caliper. Matt Wright On most cars, the next step is to remove the brake caliper so the brake pads will slide out through the top. On a few cars, the pads will come out without removing the caliper, but this is not common.
Do you need to remove brake clips before replacing brake pads?
There should be two clips inside the brake system that need to be removed prior to removing the pads themselves. Make sure to set the clips aside someplace safe for reuse when installing the new brake pads. If the clips are damaged, you can often purchase replacement ones at your local auto parts store.
How do you remove rotors from brake pads?
Once the pads are off, remove the rotor. On many vehicles, you’ll need to remove the caliper mounting bracket in order to remove the rotor. The brake caliper bolts to the brake caliper mounting bracket which bolts to the spindle assembly. To remove the brake rotor, first remove the brake caliper and then remove the brake caliper bracket.
How do you remove a brake caliper from a car?
Remove the caliper by pulling it up and away from the rotor. If the caliper is stubborn, you may need to use a large screwdriver or pry bar to help remove it. Remove the brake pads from the caliper (this is only necessary for fixed calipers).
How do you replace disc brakes on a car?
On some rear disc brakes, the caliper pistons screw in, and require the disc brake pad spreader set to be seated properly. Take the caliper off the bungee cord and put it back on. VERY IMPORTANT – DO NOT OVERTIGHTEN the caliper bolts.
How do you replace a brake adjuster on a car?
Remove the assembly that captures the adjuster, then the adjuster itself. Note the adjuster direction as it will need to go back in the same way. Lightly lubricate the threads with high-temp grease. Remove the shoes and emergency brake cable clip if required. Use a screwdriver to remove clip and pliers to reinstall.