What should I replace my 240Z carburetor with?
Things like gaskets, washers, fuel-line hoses, the needle-and-seat assembly, and much more can be found in carburetor kits. These are all parts that can’t just be repaired, so you’ll want to just replace them outright. We sell 240Z Carburetor Kits for all years:
Can a Datsun 240Z be converted to a Round Top?
Datsun 240Z & 260Z SU carb setup conversion from flat top to round top carbs. Built like the non-US setups. Looks original and most wont notice the difference. The conversion setups we build will pass emissions if your emissions equipment are working correctly with an engine in good operating condition.
What kind of choke does a Datsun 240Z carburetor use?
Datsun 240Z choke cable rubber. New reproduction choke cable rubber grommet for Datsun 240Z and 260Z, 1972-74. This… Oil for running in your Datsun 240Z carburetors.
Where does the base gasket fit on a 1971 240Z?
New round top carburetor base gasket for 1971-73 240Z. Gasket fits between the carburetor and intake. New pair of carburetor to air cleaner gaskets.
Things like gaskets, washers, fuel-line hoses, the needle-and-seat assembly, and much more can be found in carburetor kits. These are all parts that can’t just be repaired, so you’ll want to just replace them outright. We sell 240Z Carburetor Kits for all years:
Datsun 240Z & 260Z SU carb setup conversion from flat top to round top carbs. Built like the non-US setups. Looks original and most wont notice the difference. The conversion setups we build will pass emissions if your emissions equipment are working correctly with an engine in good operating condition.
What should float be on Datsun 240Z SU carburetor?
Use the chart below to determine if your float level is accurate or not. The rebuild kit comes with a small ruler that will help you with this. You are looking for the distance between the float and the top of the bowl to be 10.31mm, and you can bend the little metal tab attached to the float to change this distance.
How do you rebuild a Datsun 240Z Su gasket?
Unscrew the dampening rod at the very top of the bell housing and replace the old gasket with the new one provided in the rebuild kit. Slide it back into place, but do not screw it on just yet. You need to pour in some Marvel Mystery oil while the dampening rod is in place, but not completely removed.