Where are the timing marks on a Nissan pick up?
The cam mark should be at about the 3 o’clock position and the crank mark will be about the 5 o’clock position. Look at the timing chain and find the two links that are a different color install chain so as to match these two links to timing marks on sprockets. Install guides and tensioner .
Do you need an owner’s manual to change a timing chain?
Locate your owner’s manual. You will most likely need it to disassemble and reassemble various parts. Also verify that your model is equipped with a timing chain and not a timing belt. These two parts perform the same task, but replacing them can be quite different. This procedure is only for replacing a timing chain.
How do you change the timing chain on a radiator?
Trace the radiator hoses from the radiator back to the engine. Squeeze the hose clamps with pliers and slide them back onto the hose. Wiggle the hose to break it free and move it out of the way. There is no need to remove the radiator.
How do you change the timing chain on a water pump?
Remove the belt. Once tension is released, the belt should slide off of the other pulleys easily. Remove the heater hoses from the water pump. If your model has heater hoses attached to the water pump, loosen the hose clamps with a screwdriver and slide them back onto the hose. Wiggle the hose and pull it off of the water pump.
Where are the timing marks on the crankshaft?
For the crankshaft below, there probably will be a timing mark on the damper pulley that lines up with another mark on the lower cover. Or, the service manual may direct you to the transmission end of the engine to look through a hole in the bellhousing for a timing mark on the flywheel.
How do you change the timing on a camshaft?
To adjust the timing, loosen the distributor holding bolts and rotate clockwise or anticlockwise it to get the desired ignition timing. You need the marker on the timing belt cover to get the correct timing. Without the marks, you would have to remove the pulley to check the crank pulley timing mark for TDC and then make your mark on the cover.
How do you line up the timing marks on a car?
A hydraulic tensioner takes care of this for you. Once the tension’s set, place a socket on the big nut holding the front pulley on and use it to turn the engine over — two complete crankshaft revolutions in the direction of normal rotation. Line up all the timing marks again.