Why is my sunroof not working on my Volvo S40?
Once it was safe to exit the freeway, we pulled into a gas station and examine the sunroof to make sure it was shut properly, which it was, not understanding why this was happening, he and I used as many pieces of napkins and cloth that we could find to sop up as much water as we could and as best as we could.
Why are my headlights not working at night?
Still, if you drive a lot, especially at night when you must constantly change between high beams and low beams, you might wear out the headlight switch. It doesn’t take long to restore fogged headlights and night visibility.
What to do if your high beam light is not working?
Check your owner’s manual to be sure which kind of high beam bulb you need and get familiar with the fuse box in case the high beams stop working. Finally, practice using a digital multimeter so you can rule out electrical problems before replacing other components. A blown high beam headlight bulb, an easy fix.
Why are the lights in my house not working?
10 Reasons Why Your Lights Don’t Work 1. Plug or wall switch. Not to suggest that you’re a dim bulb (pun intended), but have you made sure the fixture is… 2. Circuit breaker. Is anything else in the room failing to turn on? If so, check your service panel (breaker/fuse box)… 3. Light bulb. …
What happens when one of the headlights is not working?
When one of the headlights is not working, the bulb of the faulty lamp may have burnt. The lifespan of bulbs is limited and this is greatly dependent on usage as well as magnitude of vibration they are exposed to. There is no way the tungsten filament in the incandescent bulb will not burn out.
Why are my spotlights not working after installing?
A common mistake installers make with negatively switched systems is that they tap into what they assumed was the high beam hot wire (negative switched systems have no hot-wire), when in fact it was minor current bleeding through the low beam filament. Now that the low beam filament is gone and replaced with LED, the spotlights do not work.
What causes a light bar to stop working?
PROBLEM: Driving Lights or Lightbar stopped triggering from high beam after fitting LED headlight conversion kit. CAUSE: We see this occurring with Toyota’s and Mazda/Ford which mostly have negatively switched headlights.
Is there a way to fix a faulty headlight switch?
It is not advisable to endeavor to fix wiring problems on your own. The Cause: Faulty relay, module, dimmer switch, headlight switch, etc. The Fix: Replace the faulty components.
The problem is that there are two drainage channels on each side of the sunroof, and when they become blocked by dirt, heavy rain will go into your car rather than being channelled off correctly. This can be an easy fix though, and simply requires a good clean of the top of the car to unblock those drainage channels.
Why does my Volvo S40 use so much oil?
You find that you have to fill up your oil a lot more than you should be. A common problem in most 1.6-litre S40s, this will have one of two causes. There are two weak points in the oil system, the fuel pump and the water pump. When either of these fails, it causes overheating and means that your car will be using a lot more oil.
When did the new Volvo S40 come out?
From the February 2004 issue of Car and Driver. One shift into our driving experience with the all-new S40, and we realized Volvo’s second-generation small car had taken a big step toward becoming a driver’s machine. That’s because now it can actually be shifted by the driver.
Why are the seats on my Volvo S40 creaking?
The seats in the front of the S40 creak excessively when you sit on them. Most mechanics will assume that this is a problem with the runners, but the real issue is going to be internal damage on the seats themselves.