What are the torque settings for the big ends?
Tighten bolts (1-10) again to 41 Nm (30 ft. lbs.) PLUS 1/4 turn in sequence shown. Install main bearing bedplate to engine block bolts (11-20), and torque each bolt to 28 Nm (20 ft. lbs.) in sequence shown. 1997 Jetta: Torque settings..vw..the head, fly wheel, big ends. [1] Always replace bolts. Exhaust Manifold to Cyl. Head
Are the torque spec from a SR20DET are the same?
Are the torque spec from a SR20DET are the same as the SR20DE ??. And where can i get them ? It all depends on what DET you are speaking of. Blluebird,GTI-R, Silvia?? and what torque specs are you looking for??
What are the torque settings for a Jetta?
Install main bearing bedplate to engine block bolts (11-20), and torque each bolt to 28 Nm (20 ft. lbs.) in sequence shown. 1997 Jetta: Torque settings..vw..the head, fly wheel, big ends. [1] Always replace bolts. Exhaust Manifold to Cyl. Head Oil threads and contact surfaces.
What should the torque settings be on a cylinder head?
Tighten the cylinder head bolts in the sequence shown. Using the 4 step torque turn method, tighten according to the following values: CAUTION: Do not use a torque wrench for the following step. Step 5: Install and tighten bolts (1-10) in sequence shown, to 41 Nm (30 ft. lbs.) .
How much torque does a SR20 camshaft have?
Evenly tighten 1/2 turn on each bolt until all of the caps are snug (1.4 ft -lb and again to 4.3 ft -lb). Then final torque the bolts from the center bolts out ward to 6.7 to 8.7 ft -lb for all of the bolts with a 10 M.M. head. The 2 larger bolts (12M.M. head) closest the distributor are torqued to 13 to 19 ft-lb. 10.
Are the torque spec from a SR20DET are the same as the SR20DE ??. And where can i get them ? It all depends on what DET you are speaking of. Blluebird,GTI-R, Silvia?? and what torque specs are you looking for??
What should the torque settings be on a 3SZ-VE?
3sz-ve 1.5 torque settings for big end/main bearings/cylinder head. Here is a video on how to use a torque wrench which will help. Step 2 – 60 Nm.
Where do you put the distributor drive pins on a SR20?
Install the cams (the one with the distributor drive slot goes on the exhaust side) with the sprocket dowel pins in the same position as the old cams. 9. Reinstall all of the bearing caps, oilers and baffle.