When should I replace my mower belt?
There’s no definite amount of time that a mower belt is supposed to last, but increased mower use shortens the interval in which a belt needs replacement. Simply put, more use equals more wear. Additionally, faulty belts or mechanical failures like a seized pulley can make lawn mower belts break prematurely.
What should I do if my drive belt is loose?
A loose belt, simply stated, looks and feels loose. If this appears to be the case, you should have a mechanic adjust the belt tension so that it doesn’t come off and damage your engine or leave you stranded. There are two types of drive belts used in automotive vehicles.
How can I adjust the tension on my drive belt?
When the tension is correct, tighten the adjusting strap bolts and the pivot bolt. Some cars have an idler-wheel pulley which presses on the belt. If yours does, turn the screw adjuster to move the wheel and alter the belt tension. This is often simpler than moving the generator. Unscrew the nut or nuts to split the two halves of the pulley.
Can a club car drive belt be too loose?
The rule of thumb is that the drive belt must neither be too tight nor too loose. If the drive belt in a Club Car golf cart is loose then you won’t get the required speed while driving. If the belt is too tight then your starter will be under strain and this should be avoided.
Can a screwdriver be used to adjust a drive belt?
Do not use a screwdriver or similar tool to lever the belt over the pulley. If the belt is too tight to be fitted by the winding method, it is too small anyway, and you must get one of the proper size. Remove the old belt on a shim-adjusted pulley in the same way as that used for adjustments.
What’s the best way to loosen a drive belt?
A tensioner pulley can be loosened by inserting a breaker bar or socket wrench into the hole in the center of the pulley and twisting it clockwise. In other vehicles, you will need to loosen the alternator bolts and either tip it forward or slide it toward the motor within its bracket to loosen the belt.
How do you tighten a drive belt on a riding mower?
(The lock-washer to the bolt head and the heavy flat washer to the crankshaft pulley.) Using a torque wrench, tighten the crankshaft pulley bolt, to a torque of 37.5 – 50 foot pounds (51-68 Newton Meters). Place the lower transmission belt into the upper “V” Pulley closest to the engine on the crankshaft pulley.
How can you tell if your drive belt is loose?
Choose your car for a more accurate estimate. A loose drive belt will often be noisy, squeaking a bit, or emitting a high-pitched squeal. The most obvious sign of a loose drive belt, though, is in its appearance and tension. A loose belt, simply stated, looks and feels loose.
How do you remove a belt from an idler?
Loosen the bolt with a ratchet and socket until tension is relieved on the belt. Locate the idler pulley and loosen the center retaining bolt using a wrench and turning the bolt counterclockwise. Once you can wiggle the pulley, you will be able to remove the belt from the pulley groove.