What should I do if my Nissan speedometer is not working?

Before ordering any parts, test the vehicle speed sensor. The factory service manual is a good source for diagnostic information. If the sensor is in good working order, try the donor cluster to verify that it’s working properly. These instructions will work for nearly any Nissan that uses a similar speedometer.

Why is the speedometer on my truck 94 not working?

CLICK HERE TO RESET YOUR PASSWORD! The speedometer on the ’94 finally broke for the PO just before we bought it. It had been giving him problems for awhile. A couple times on the drive home, it would flip up to speed and then back to zero. 99% of the time it was zero.

Why is the speedometer not working on my Infiniti Revolution?

Took it to Infiniti dealer and they pointed to the revolution sensor I already found. Then, they suggested trying to replace the instrument cluster. Did that and it’s worse! What used to be an intermittent speedometer failure with following abs light (all other gauges working) is now no speedometer with abs light on at startup.

What causes the needle on the speedometer to go up or down?

Scenario: while you are driving, your speedometer needle abruptly goes up by 10 miles per hour or more, then swings back down sharply. This continues the entire time you are driving, with the needle bouncing between different speeds even when you are drivin g steadily. The speedometer indicator gauge may come on if the car has one.

Where is the speed sensor on a truck 94?

The 2nd speed sonsor in the trans is a dummy to fill the hole. 91-93 4X4’s and 2X4’s used that hole for an output speed sensor, but 94+ 4X4’s used the one in the transfer case. The VSSB is the white box behind the glove box that runs the speedo and feeds the output speed sensor reading to the ECM (and radio for SCV on 95+ trucks).

Can you remove the motor from a speedometer?

Remove the two screws that hold the speedometer motor in place. The next step is a difficult part of the project. If you try to pull the motor off without holding the shaft, you run the risk of pulling it through and ruining the small return spring.

How do you remove the odometer from a Nissan?

Once you’ve removed the solder and screws, you can remove the board. Be aware that the odometer’s motor is plugged into the board. After removing the circuit board, remove the single screw that holds the odometer motor in place and remove the odometer motor.

How do you remove a speedometer from a cluster?

Set the speedometer back into the cluster and secure it with four screws from behind. Finally, reinstall the cluster. Ultimately, the easiest thing to do would be to use the entire donor cluster or possibly the speedometer itself (if your donor cluster is a base model version and you want to retain your tach.

How do you get speedometer back to home position?

Both the shaft and the motor need to be at their “home” position which is 0 mph. Returning the motor to its home position is the hardest part. You may need to solder the motor to the circuit board, screw it into the cluster, connect the cluster and power-on the ignition. This will bring it back to the home position.

Are there any issues with the Nissan speedometer?

Speedometer issues SOLVED! Some of you may remember my posts about having a failed speedometer and odometer with the other guages working fine. Well… after 1 week of testing wires, continuity, resistance, tracing, replacing 2 ECU computers, 2 speedometer heads, and 1 vehicle speed sensor.

Why is my odometer not working on my speedometer?

Some of you may remember my posts about having a failed speedometer and odometer with the other guages working fine. Well… after 1 week of testing wires, continuity, resistance, tracing, replacing 2 ECU computers, 2 speedometer heads, and 1 vehicle speed sensor. It all came down to the plastic gear on the vehicle speed sensor itself.

Where is the speed sensor on a Nissan?

After a bit of time on the google, it looks like it goes – driveshaft > speed sensor speedo pinion gear > speed sensor > wiring harness > fuses > instrument cluster > ECU. Unplugged the sensor and tested the voltages while driving down the street with a multi meter clipped onto the two male pieces within the plug. No voltage being produced.

Why is the speed sensor on my Nissan not working?

It happens sometimes, usually when the car has been standing for the day in sunlight, and it goes away by itself. I took it to a dealer and dealer replaced Speed Sensor (CODE: P0500) – spent $250 on it already The issue hasn’t been fixed yet, the dealer says to bring the car when the issue is there.

Do you need to replace the speedometer dial?

Not every speedometer related problem needs a replacement job. It depends on the cause. In case the dial is the problem, you can easily replace the dial alone. Problems with the inbuilt computer will require replacement.

Where are the speed sensors on a car?

There is a Vehicle Speed Sensor (VSS) on the Transmission. VSS #1 used for shift points or something. Also, there is VSS #2 on the transfer case used for Cruise Control. Then there is the Speedometer Cable. That cable is what goes to the gauge cluster and moves the needle we see.

Do you need tooth counts on a speedometer?

The tooth counts are applicable whether its a cable-drive speedometer, or a Vehicle Speed Sensor (starting in 1992) style assembly. RockTrak NP241OR’s do not apply since they are natively and directly electronic speed sensing.

When did they start making speedometer gears for jeeps?

This guide is useful for calibrating and sourcing speedometer gears for your Jeep transfer cases, ranging from the early New Process units (starting in 1980), the Dana 300 (starting in 1981) through the later New Process units made until 2006.

What happens when you change gears on the speedometer?

As a quick reminder, if you choose a smaller driven gear, the speedometer will be driven faster. If you choose a larger driven gear, the speedometer will be driven slower. Many charts on the web are innacurate. These figures below derive from actual individual calculations based on tire diameters and industry-standard formulas.

What happens when a car speed sensor wears out?

Over time, the VSS can wear out like any electronic device. Since the data can be used for various subsystems, a failing VSS may result in a number of symptoms such as poor shift timing, erratic speedometer readings, or anti-lock brake system issues. It may also turn your Check Engine light on intermittently when accelerating.

What do you need to know about Cable X speedometer?

The Cable X is the easy, inexpensive way to operate your stock mechanical speedometer with updated transmission equipped with a vehicle speed sensor. The Cable X is basically an universal adapter that will pick up the electronic speedometer signal and will operate the cable driven speedometer to the corresponding speed.

Where is the speedometer sensor on a car?

The speedometer sensor is located inside the transmission and attached to a driveshaft, which impacts multiple functions of the car. Due to this fact, it’s possible that the Check Engine Light will light up on the dashboard if a sensor problem is discovered by the vehicle’s CPU.

What happens when a speedometer sensor loses power?

Vehicle loses power Today’s cars and trucks have electronic fuel injection, which is controlled by the onboard computer. The EFI supplies fuel to the engine based on input from multiple sensors; one of which is the speedometer sensor.

When to see a mechanic about your speedometer?

If you feel you are driving faster or slower than what the speedometer reads, it is a good idea to have your vehicle inspected by Your Mechanic, as this might be a problem with the sensor that can be repaired or an indication that the speedometer sensor needs replacement.

Why is the odometer not working on my Nissan?

As you drive the speedometer sends out a current that varies with speed and that drives a servo motor that spins the gears of the odometer. So the problem could be with the servo motor, the gearing, or the speedo (most likely problems anyway.) I am assuming your speedo works? To get to any of it you will have to take the gauge cluster out.

Why is the speedometer on my Nissan Frontier not working?

While there are a variety of reasons your Nissan Frontier speedometer is not working, the most common 3 are the vehicle speed sensor (VSS), a faulty speedometer, or an electrical issue. See what others are asking about their Nissan Frontier. Get answers from RepairPal’s community of auto experts and enthusiasts.

Are there any issues with the speedometer in Nissan Pathfinder?

– Nissan Forum | Nissan Forums Speedometer issues SOLVED! A forum for the legendary Nissan Pathfinder and Infiniti QX4. Speedometer issues SOLVED!

Is there a problem with my Nissan Pathfinder?

I have a 1996 Nissan Pathfinder and up till a few days ago everything was fine. A few days ago I triedstarting the Pathfinder and got a really slow errg noise like starter tried to engage but didn’t kinda like battery was dead. So I took starter and battery out and had it tested the two turned out fine. Still no success.

Is the 93 Xe Nissan Pathfinder a bad starter?

Let us know in the Values & Prices Paid section! My 93 XE Nissan Pathfinder has had a problem starting for the last year and a half, it started out that i thought i had a bad starter. I went out and bought a starter, just to find out that it still had the same problem starting. I put in a cheater switch, too bypass the one in the dash.

What should I do if my odometer is not working?

The good news is that this is an easy fix, as demonstrated by YouTuber Chris Fix. If both your odometer and speedometer are not working, then it’s likely your speed sensor needs to be replaced.

Why does my odometer stop spinning when I hit 200, 000 miles?

The only way you’ll know if your car hits the 200,000 mile mark is by having a functioning odometer. But the plastic gears that turn an analog odometer have a tendency to break, which causes the odometer to stop spinning. The good news is that this is an easy fix, as demonstrated by YouTuber Chris Fix.

Where is the speedometer and odometer located?

If both your odometer and speedometer are not working, then it’s likely your speed sensor needs to be replaced. These are easily installed and located near the back of your transmission.

Why does the speedometer work but not the odometer?

Proton Iswara’s (aeroback) dashboard, speedometer works but not the ODOMETER. For analogue dashboards, these normally work hand-in-hand or they don’t altogether. Initial guess was that the gear was broken, luckily it was a wrong guess.

Navigation