How are the two CV joints on a drive axle replaced?
The two CV joints on a drive axle can be replaced separately. That involves removing the axle, removing the axle boot and then the joint, installing a new joint, new grease and the boot, then, reinstalling the axle in the vehicle. This is almost never done.
What’s the best way to change an axle?
By this time, you can put the wheel back on the vehicle (again, the same as you would when changing a tire). After the wheel is on, you can lower the car off the jack and jack stands. Tighten the axle nut. Finally, you can retighten the axle nut once the vehicle is back on the ground.
How are the wheels connected to the transaxle?
Your CV joint has failed. The wheels of your front-drive vehicle are connected to the transaxle via axles that have constant-velocity-type universal joints at each end. There is an inner and outer joint on the left and right axles.
How to replace a front axle on a Dodge Ram?
This video covers how to replace a front axle universal joint and a hub or wheel bearing in a 1999 dodge ram 1500 4 wheel drive. Very similar to a 2500. It may be less damaging to loosen the hub bolts and tap on them with a hammer vs the method shown in this vid. Loading…
The two CV joints on a drive axle can be replaced separately. That involves removing the axle, removing the axle boot and then the joint, installing a new joint, new grease and the boot, then, reinstalling the axle in the vehicle. This is almost never done.
By this time, you can put the wheel back on the vehicle (again, the same as you would when changing a tire). After the wheel is on, you can lower the car off the jack and jack stands. Tighten the axle nut. Finally, you can retighten the axle nut once the vehicle is back on the ground.
How do you remove axle from ball joint?
To do this you must undo the lower ball joint allowing the room for the axle removal. The ball joint nut may or may not have a cotter pin that must be removed to disconnect the ball joint.
Your CV joint has failed. The wheels of your front-drive vehicle are connected to the transaxle via axles that have constant-velocity-type universal joints at each end. There is an inner and outer joint on the left and right axles.