How do you program a Nissan Altima throttle body?

How do you program a Nissan Altima throttle body?

Turn the ignition switch on and wait 3 seconds. Immediately after the 3 seconds, the accelerator pedal must be pressed and released 5 times within 5 seconds. Wait 7 seconds and fully press the accelerator pedal and hold for approximately 20 seconds until the check engine light stops blinking and stays on.

Why did my Altima 2.5L not start up?

My 2013 altima 2.5L could not start an engine. It turned on P0101 and P2119. After replacing an air filter and cleaning MAF and throttle body, it seemed that everything is fine. However, in the next day, ECM set P0101 again. I replaced MAF filter and PCV valve, but it could not solve my problem.

How much does a Nissan Altima patch cost?

And according to the lawsuit, if a consumer has the repair plate installed, the Altima owner will need to pay about $500 toward the repair offered by the bulletin, even though the materials for the repair cost only $111.57. FWIW my patch repair was in the $400 range too…but I removed/replaced the carpet and seat myself.

Do you need to do a Nissan throttle body relearn?

If you own a 2002-2011 Nissan Altima and clean or replace the throttle body or replace the ECU, you must do a Nissan Throttle Body Relearn Procedure to get a proper idle speed. Nissan calls this an Idle Air Volume Learning Procedure You can also perform this procedure if you feel the idle speed it out of spec.

Can You reprogram an ECM on a 1999 Nissan?

SERVICE INFORMATION • In-vehicle ECM reprogramming is available to update the ECM of certain 1999 vehicles (listed in Applied Vehicles above), and all 2000 and later vehicles. • This reprogramming allows the vehicle ECM to be upgraded to the latest operating specifications without removal or replacement of the ECM.

My 2013 altima 2.5L could not start an engine. It turned on P0101 and P2119. After replacing an air filter and cleaning MAF and throttle body, it seemed that everything is fine. However, in the next day, ECM set P0101 again. I replaced MAF filter and PCV valve, but it could not solve my problem.

And according to the lawsuit, if a consumer has the repair plate installed, the Altima owner will need to pay about $500 toward the repair offered by the bulletin, even though the materials for the repair cost only $111.57. FWIW my patch repair was in the $400 range too…but I removed/replaced the carpet and seat myself.

If you own a 2002-2011 Nissan Altima and clean or replace the throttle body or replace the ECU, you must do a Nissan Throttle Body Relearn Procedure to get a proper idle speed. Nissan calls this an Idle Air Volume Learning Procedure You can also perform this procedure if you feel the idle speed it out of spec.

How to do idle and volume relearn in Nissan?

Turn the ignition switch on without starting the engine for at least 2 seconds. Turn the ignition switch off for at least 10 seconds. Again, turn the ignition on for at least 2 seconds. Turn the ignition off for at least 10 seconds. This action will inform the computer on the new release position of the accelerator pedal and the closed position.