How do you remove the steering wheel from a Nissan Frontier?

How do you remove the steering wheel from a Nissan Frontier?

Nissan P/N 01141-00411). Remove the bolts and lift the air bag module upward from the steering wheel. Unplug the connectors and put the air bag on a surface in a safe place where it won’t fall off and make sure the back side of the module is facing down. Remove the steering column nut and use a steering wheel puller to remove the steering wheel.

How do you change the steering column cover on a Nissan?

Install the Nissan steering column cover. Install the steering wheel and torque the center bolt to 35Nm. Install the steering wheel and torque the center bolt. Install the airbag. Connect the steering wheel button and airbag wires. Torque the bolts that secure the airbag to the steering at 10Nm.

How to remove the air bag from a Nissan Frontier?

Remove the side covers (or switches, if equipped) on the sides of the steering wheel to access the bolts that hold the air bag module. You’ll need Torx T-50X socket to get the tamper-proof Torx bolts out (new bolts are recommended by Nissan when you reinstall them…FYI. Nissan P/N 01141-00411).

How to change the steering angle sensor on a Nissan?

Park your Nissan and set the parking brake. Remove the key from the ignition. Open the hood and disconnect the negative battery cable from the battery terminal. Wait 15 minutes. Your browser does not support video tag. Press the horn twice to discharge any residual current. Remove Torx bolts on the side of the steering wheel.

Nissan P/N 01141-00411). Remove the bolts and lift the air bag module upward from the steering wheel. Unplug the connectors and put the air bag on a surface in a safe place where it won’t fall off and make sure the back side of the module is facing down. Remove the steering column nut and use a steering wheel puller to remove the steering wheel.

Remove the side covers (or switches, if equipped) on the sides of the steering wheel to access the bolts that hold the air bag module. You’ll need Torx T-50X socket to get the tamper-proof Torx bolts out (new bolts are recommended by Nissan when you reinstall them…FYI. Nissan P/N 01141-00411).

How to remove the dash under the steering wheel?

1. grab SOMETHING FLAT.HERE, HOLD UP… Remove the side cap. Use something that won’t scratch it to just pop it off. Pop off the fuse panel and unscrew this screw. You’ll need to remove this panel later to get the wire through.

Is there a horn ring on a Nissan Frontier?

FYI, there is no “horn ring” if you do have an air bag; you are more likely to have a bad clock spring assembly, which Nissan parts catalog refers to as a “wire assembly-steering air bag.” You didn’t mention if you had an air bag or not, so I’m assuming you do.