How many wires are in a Nissan Sentra distributor?
Dont know terminal is which but you have 4 for camshaft position sensor (2 grounds, 1 power and 1 signal it looks like) 4 wires for spark control (1 power and 1 ground for the primary coil transistor and then 1 power wire straight to the coil primary winding and 1 wire going into an external resistor)
Where are the spark plug wires in the correct order?
If you still don’t understand, you can also visit your car dealer or service centre. You can always request them to explain the process of putting the spark plug wires into the correct order. As you know, the rotor located underneath the distributor cap. It can spin clockwise or anti-clockwise.
What do black and white light signals mean on a Nissan Sentra?
Black/ White is CMP signal. Blue is 5v Ref. White/ Black should be Power transistor control wire. If you connect a test light to batt + and touch on that wire either at the ecm or at the connector with engine cranking, you should see the light flicker.Since you stated that you have Spark and injector pulse, it is expected to see a pulsation there.
What kind of fuel injection does a Nissan Sentra use?
It’s normal. Sequential Fuel Injection (SFI) SFI vehicles can operate in one of 2 injection modes: simultaneous or sequential. In simultaneous injection mode, fuel is injected into all cylinders at same time. In sequential injection mode, injectors are triggered in spark plug firing order.
What kind of engine does a Nissan Sentra have?
Front wheel drive. Internal Combustion engine. The ICE drives the front wheels of the vehicle. How long is this vehicle, 1994 Nissan Sentra Sedan? How wide is the vehicle, 1994 Nissan Sentra Sedan?
What kind of wire is used for spark plugs?
Some people know them as high tension cables or high tension leads, while others know them as spark plug cables. These sets of wires are engineered to connect an ignition coil, magneto or distributor to each other of the spark plugs in an internal combustion engine.