How to reset the idle ON a Nissan Murano?
Fully depress the accelerator pedal. Wait 7 seconds, fully depress the accelerator pedal and keep it for approx. 20 seconds until the MIL stops blinking and turned ON.
What should a Nissan Murano idle at?
Generally, it is estimated that the idle speed of your Nissan Murano should be between 750 and 900 rpm. If your Nissan Murano does not idle, or if your idle speed is unstable, this can be detected by slight variations in the idle speed of your Nissan Murano from 100 rpm up to the engine unit idle speed.
When to release the accelerator on a Nissan Murano?
Fully release the accelerator pedal within 3 seconds after the MIL turned ON. Start engine and let it idle. Wait 20 seconds. Rev up the engine two or three times and make sure that idle speed and ignition timing are within the specifications.
When to do idle air volume learning in Nissan Murano?
Each time electric throttle control actuator or ECM is replaced. Idle speed or ignition timing is out of specification. Before performing Idle Air Volume Learning, make sure that all of the following conditions are satisfied.
What’s the idle air volume learning procedure for Nissan Versa?
Repeat the following procedure quickly five times within 5 seconds. Fully depress the accelerator pedal. Wait 7 seconds, fully depress the accelerator pedal and keep it for approx. 20 seconds until the MIL stops blinking and turned ON. Fully release the accelerator pedal within 3 seconds after the MIL turned ON. Start engine and let it idle.
How to learn idle air volume Nissan Maxima?
Check that all items listed under the topic PREPARATION (previously mentioned) are in good order. Turn ignition switch OFF and wait at least 10 seconds. Confirm that accelerator pedal is fully released, turn ignition switch ON and wait 3 seconds. Repeat the following procedure quickly five times within 5 seconds.
Each time electric throttle control actuator or ECM is replaced. Idle speed or ignition timing is out of specification. Before performing Idle Air Volume Learning, make sure that all of the following conditions are satisfied.
Fully release the accelerator pedal within 3 seconds after the MIL turned ON. Start engine and let it idle. Wait 20 seconds. Rev up the engine two or three times and make sure that idle speed and ignition timing are within the specifications.
Repeat the following procedure quickly five times within 5 seconds. Fully depress the accelerator pedal. Wait 7 seconds, fully depress the accelerator pedal and keep it for approx. 20 seconds until the MIL stops blinking and turned ON. Fully release the accelerator pedal within 3 seconds after the MIL turned ON. Start engine and let it idle.
Check that all items listed under the topic PREPARATION (previously mentioned) are in good order. Turn ignition switch OFF and wait at least 10 seconds. Confirm that accelerator pedal is fully released, turn ignition switch ON and wait 3 seconds. Repeat the following procedure quickly five times within 5 seconds.