What to do if your Honda odometer is broken?
However, if it does, then one needs to inspect the wiring at the speedometer head for any signs of breakage. If the wires turn out to be good, a replacement of the speedometer head would be the next best repair option.
What to do if your Honda speedometer won’t work?
Read on to learn how to fix your Honda’s failing speedometer and odometer. This article applies to the Honda Civic (1992-2002) and Accord (1992-2002).
Why is my odometer not working on my car?
A shorted out cell in the battery, a faulty odometer display or a bad vehicle speed sensor could cause this issue. Thus, troubleshooting these components with an Expert’s help and replacing them as needed, is what a person could do to fix this issue.
Where is the speedometer on a Honda Accord?
It is in the back of the engine compartment on top of the transmission. Remove the air intake hose and filter. Remove the electrical connector on top of the VSS by squeezing the clip and sliding it off of the sensor. Remove the VSS bolt with a 10 mm socket, ratchet, and extension. To remove the VSS, wiggle and pull it straight out.
How can I get my Honda odometer to work?
Use a Phillips screwdriver to remove the screws of the dashboard bezels. There is one near the A/C controls and another above the gauge cluster itself. Undo several clips on both sides of the dashboard bezel, and remove it. Use a 1/4” ratchet, socket and extension to remove the wiring cluster from the dashboard.
Read on to learn how to fix your Honda’s failing speedometer and odometer. This article applies to the Honda Civic (1992-2002) and Accord (1992-2002).
It is in the back of the engine compartment on top of the transmission. Remove the air intake hose and filter. Remove the electrical connector on top of the VSS by squeezing the clip and sliding it off of the sensor. Remove the VSS bolt with a 10 mm socket, ratchet, and extension. To remove the VSS, wiggle and pull it straight out.
How do you remove the speed sensor on a Honda Accord?
Remove the electrical connector on top of the VSS by squeezing the clip and sliding it off of the sensor. Remove the VSS bolt with a 10 mm socket, ratchet, and extension. To remove the VSS, wiggle and pull it straight out. The drive link, which is a small part that links the speed sensor to the transmission, should come out as well.