What is the fault code for a Valtra truck?
A312 A1A3/2 Gearbox oil temperature value (sensor B14) impossible (below —50˚C). Faulty sensor or its wiring 3 ge 370/11 g 370/23. A313 A1A3/4 Signal from gas pedal position sensor B15 below 1 V (DC) or over 7 V (DC).
What are the Suspect Parameter Numbers on J1939?
Suspect Parameter Numbers (SPN) on J1939 data link SPN Code Description 16 Engine Fuel Filter (suction side) Differ 18 Engine Extended Range Fuel Pressure 19 Engine Extended Range Engine Oil Pressur 20 Engine Extended Range Engine Coolant Pre
What are the symptoms of stored trouble code p1130?
What are the symptoms of code P1130? 1 Stored trouble code (s), and an illuminated warning light. 2 Increased fuel consumption and higher-than-acceptable levels of exhaust emissions. 3 Power loss to varying degrees, depending on the exact nature of the problem. 4 Vehicle may not pass an emissions test.
When is the p1138 code detected in a swirl control valve?
The P1138 code is detected when the target opening angle of swirl control valve controlled by Engine Control Module (ECM) and the input signal from swirl control valve position sensor is not in the normal rang.
What is the solenoid valve on a swirl?
The solenoid valve controls swirl control valve’s shut/open condition. This solenoid valve is operated by the Engine Control Module ( ECM ). The swirl control valve control solenoid valve responds to signals from the ECM.
When to open or shut swirl control valve?
Also, except when idling and during low engine speed operation, this system opens the swirl control valve. In this condition, this system tends to increase power by improving intake efficiency via reduction of intake flow resistance, intake flow. The solenoid valve controls swirl control valve’s shut/open condition.
What does the swirl control valve do on a Nissan OBD2?
Also, except when idling and during low engine coolant temperature, this system opens the swirl control valve. In this condition, this system tends to increase power by improving intake efficiency via reduction of intake flow resistance, intake flow. The swirl control valve is operated by the Engine Control Module ( ECM ).