Why did my F-150 blend door actuator go out?
If you switch it towards heat a little bit, and the noise stops, your F-150 blend door actuator has gone out. A common issue in these trucks is the failure of the potentiometer that senses when the actuator has turned fully.
What do you need to replace blend door actuator?
You need an 8mm box wrench, along with a 7mm or equivalent SAE socket and socket wrench. I used a paint can opener to help pull the plastic off. The blend door is actually behind the radio, so the first step is to get the radio out. The silver panels on each side of the radio simply pull straight out as pictured.
What does the blend door do on a Ford F-150?
A Ford F-150’s blend door is the device that controls how much heat or AC comes through the HVAC system. For the last 20 or 30 years in these trucks, they have been prone to failure. I love my truck, but I wish Ford had fixed this problem by now.
What to do if your Dodge Journey heater blows cool air?
Remove the cable and/or vacuum control lines (if equipped). Remove the heater core securing brackets and/or clamps. Lift the core from the case. Do not use force. Take care not to damage the fins of the heater core when removing. To reinstall the heater core, reverse the removal steps.
What to do if your blend door blower is stuck?
If the door is stuck the heater plenum with need to be removed and the problem resolved before installing the new unit. To test the blend door operation and too double check that you are changing the correct actuator motor turn the blower motor on and work the door in each way.
How can I tell if my blend door actuator is bad?
To test the blend door operation and too double check that you are changing the correct actuator motor turn the blower motor on and work the door in each way. You will be able to feel the air change temperature or vent level. Compare the bad actuator to the new unit.
Why does my Blend door not turn on?
Since this is just a small electronic part, this won’t be unheard of. If that happens, the blend door won’t work, and it’s likely your temperature will just be stuck on one setting with no ability to adjust the intensity up and down, or alternate between things like the lower vents or the defroster.
Can a heater be removed from a blend door?
If the door is stuck the heater plenum with need to be removed and the problem resolved before installing the new unit. To test the blend door operation and too double check that you are changing the correct actuator motor turn the blower motor on and work the door in each way. You will be able to feel the air change temperature or vent level.