What happens when toe is out of alignment?
Improper toe either front or rear will very rapidly destroy a set of tires. When a wheel toes in or out just 1/8 inch, the tire will be dragged sideways forty-feet for every mile that is driven. When two tires are closer together in the front than the rear, the wheels are referred to as toed in.
What is toe out adjustment?
A toe-in condition is also called positive toe angle. * “Toe-out” is present when the wheels are further apart at the front and closer together behind the axle centerline. A toe-out condition is also called negative toe angle). Independent rear suspensions usually offer rear wheel toe adjustment.
Where is the tow hook on a Honda Accord?
Place the jack stands under the rear tow hooks located on either side of the car in front of the trunk (closest to the rear bumper) or under the rear pinch welds located directly under the rear passenger doors. Lower the vehicle onto the jack stands. Climb under the rear of the Accord and locate the trailing arm.
How do you adjust rear wheels on a Honda Accord?
Adjusting the rear wheels in a Honda Accord involves adjusting the trailing arms and the compensator arm connected to the trailing arm. Normally, this is done by an alignment shop due to the extreme difficulty involved in this process. However, if your Accord’s rear wheels are seriously misaligned,…
Where is the rear jack on a Honda Accord?
Place the wheel blocks in front of the front wheels and verify that your Accord is in “Park” or first gear (if it is a five-speed). Jack up the rear of the Accord using the rear jack point located just in front of the trunk area.
What kind of suspension does the Honda Accord have?
The Second Generation Accord has a MacPherson strut front suspension. Only Toe adjustablility is provided from the factory, however, aftermarket adjustment methods for Camber and Caster are likely available. The rear strut suspension is OE adjustable for Toe only.
Can you adjust suspension for front and rear toe?
The suspension can be adjusted for front and rear toe. For proper inspection and adjustment of the wheel ; alignment, do these checks: 1. Release the parking brake-to avoid an Incorrect measurement. 2. Make sure the suspension is not modified.
How to adjust the front suspension on a Honda Accord?
Loosen the tie-rod locknuts (A) while holding the flat surface sections (B) of the tie-rod end with a wrench, and turn both tie-rods (C) until the front toe is within specifications. 4. After adjusting, tighten the tie-rod locknuts to the specified torque.
What do you need to know about Honda Accord wheel alignment?
Honda Accord: Wheel Alignment Eighth generation (2008–2012)/ Honda Accord MK8 2008-2012 Service Manual/ Suspension/ Front and Rear Suspension/ Wheel Alignment The suspension can be adjusted for front and rear toe. Pre-Alignment Checks For proper inspection and adjustment of the wheel ; alignment, do these checks: 1.
How do you adjust the tie rod on a Honda?
Use a 12″ crescent wrench to adjust the tie rod ends. Push the car backward until the mark you made in Step 2 again faces the front of your car. Make sure the mark is still four inches above the ground. You may need to push the car forward and backward to achieve the correct measurement.