How do you bleed a clutch on a Dualis?
Fill reservoir tank with new clutch fluid Depress and release the clutch pedal slowly and fully 15 times at an interval of 2 to 3 seconds. CAUTION: Hold it to prevent releasing clutch tube from bleeding connector (2) when fluid pressure is applied in the tube.
Why does my clutch pedal have no pressure?
Q: Clutch won’t work and the clutch pedal has no pressure. Replaced master and slave cylinder and clutch flywheel but my clutch pedal isn’t getting pressure and won’t allow me to use clutch
What causes a petal to fall out of the clutch?
Check linkage. sometime the rod that pushes the t/o rod fork will fall out of the rod. It’s not attached, held in place only by spring pressure. Easy fix if that’s the case, caused by out of adjustment. Good luck , hope that’s all it is. Worst case all pressure plate componets destroyed and nothing to give petal something to push
What to do if your clutch doesn’t work?
If there is no leak, then there may be air in the clutch hydraulic system. I recommend bleeding the clutch slave cylinder and the clutch master cylinder. If you need further assistance with your clutch not working, then seek out a professional, such as one from Your Mechanic, to help you. Was this answer helpful? Thank you for your feedback!
Can you pump your clutch with your feet?
Foxy, if you pump your clutch with the feet when you car is started, it will work… but it is just temporary. you wont need to call the tow anymore. i discover that few days ago… 13 people found this helpful. Endive, i was able to keep my car going by doing that thanks but still have no idea what the actual problem is yet.
Q: Clutch won’t work and the clutch pedal has no pressure. Replaced master and slave cylinder and clutch flywheel but my clutch pedal isn’t getting pressure and won’t allow me to use clutch
Check linkage. sometime the rod that pushes the t/o rod fork will fall out of the rod. It’s not attached, held in place only by spring pressure. Easy fix if that’s the case, caused by out of adjustment. Good luck , hope that’s all it is. Worst case all pressure plate componets destroyed and nothing to give petal something to push
How to troubleshoot a clutch that won’t fully disengage?
Step 1: Collect all tools and your creeper and place them out of the way. Step 2: Raise the vehicle. Using a floor jack that is recommended for the weight of the vehicle, lift under the vehicle at its specified jacking points until the wheels are completely off the ground. Step 3: Remove the jack stands and keep them far away from the vehicle.
Where is the quick fitting on a Mini Cooper clutch?
The only other thing that would come to mind is to check the quick fitting on the other end of the clutch line that goes into the slave which is located from memory near the top of the gearbox in case its leaking and has been disturbed. The clutch line from memory is two separate lines that fit together. Again, good luck.