When did Nissan start using ISO 9141 protocol?
This pinout is associated with 33 compatible devices or models. Show them> Please note that this list is not 100% complete! ISO 9141 used in 1996-2004 Nissan models. TBD protocol was used in 2005 and 2007 and CAN for all further models.
How long does it take to diagnose Nissan p0011 code?
An error occurred while retrieving sharing information. Please try again later. The cost of diagnosing the P0011 NISSAN code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.
What is the diagnostic code for a Nissan check engine light?
Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s). Remember, these are manufacturer specific codes only. Refer to our Generic OBD II code listfor definitions on all other Nissan diagnostic trouble codes. Manufacturer Specific Codes P1105MAP/BARO Pressure Switch Solenoid Valve
What are the trouble codes on a Nissan?
Nissan Specific Trouble Codes Code Description P1105 MAP/BARO Pressure Switch Solenoid Valve P1126 Thermostat Function P1130 Swirl Control Valve Control Solenoid Val P1148 Closed Loop Control (Bank 1)
What does the p1491 code on a Nissan mean?
If the EVAP canister is OK, and there are no other visual damage to the EVAP system (e.g. loose or broken hoses), replacing the vacuum cut valve bypass valve takes care of the problem. There is a factory service bulletin for all 1998-2002 Nissan models. What does this mean? The cost of diagnosing the P1491 NISSAN code is 1.0 hour of labor.
Where is the EGR valve located on a p1491?
If the P1491 is the only active fault code present, and there are no updates/TSBs for your particular vehicle, then the next step is to locate the EGR Valve / Lift sensor / position sensor. You can usually find the EGR valve mounted between the intake and exhaust manifold of the engine.
What is the code for the vacuum cut valve?
In this instance, code P1491 will set when the PCM pulses the EGR solenoid at a set duty cycle for a specific percent lift but does not see it reach that set location or lift via the position sensor. For the Nissan / Infiniti vehicles with the vacuum cut valve by-pass valve code P1491, see the “Related Codes” section for a detailed explanation.
What does the vacuum cut valve on a Nissan do?
The vacuum cut valve bypass valve responds to signals from the ECM. When the ECM sends an ON (ground) signal, the valve is opened. The vacuum cut valve is then bypassed to apply intake manifold vacuum to the fuel tank.