How many feet should you turn your low beams on?
Use your low beams when you come within 500 feet (about one block) of an oncoming vehicle. Also use your low beams when following another vehicle within 300 feet.
What’s the best way to adjust the beam of light?
The top of the most intense part of the beam should be even with, or just below the center of the line of tape you made. Turn the side screws or bolts to adjust the horizontal field. Now, you’ll do basically the same thing with the right-left adjustment. Test your alignment on the road.
How can I adjust the height of my headlight beams?
Mark the headlight beams vertically and horizontally on the wall with masking tape. This should create a cross. Using the taped marks, measure the lines (cross) to check that they’re even. If they’re uneven, note the difference in measurements and lower the highest center line marker to the same height as the lowest center line marker.
How do you adjust the vertical light field?
Adjust the Vertical Field If you can enlist an assistant, have someone sit in the driver’s seat to turn the lights off and on as you make your adjustments. When turning the vertical field’s screw or bolt, turning clockwise typically raises the lights while turning counterclockwise lowers them.
What’s the correct way to adjust the lights on a car?
When turning the vertical field’s screw or bolt, turning clockwise typically raises the lights while turning counterclockwise lowers them. Your model, however, might work differently, so check the owner’s manual.
What to do if you drop a low beam light bulb?
The oil on your hands can compromise the glass of the bulb, reducing its lifespan. Protect your bulb from this by wearing gloves or using a tissue any time you come into contact with the glass of the new low beam headlight bulb. Be careful not to drop the bulb as you remove it from the package.
What to do when your low beam headlight blows out?
You can often tell when a headlight blows out while you’re driving, but confirm which bulb has actually blown out by leaving your headlights on and getting out of the vehicle to check. Then get back in your vehicle and turn on your high beams. Some vehicles use a single bulb for both high and low beams while others do not.
How do you adjust the beam of a headlight?
Block one of the headlights and look to see where the other beam hits the wall. It should fall at or below the horizontal tape line you marked and to the right of the vertical tape line. If it doesn’t, use the adjusters located on the headlight housing to adjust the beam until it hits the right spot on the wall.
What can cause a low beam headlight to be dim?
If it is, use a voltmeter to see how much power, if any, is reaching the headlights. If there is no power reaching them, there is a break in the wiring somewhere between the fuse panel and the headlights themselves. Thanks! What can cause the light to be dim except when on the high beam setting?