Is there a transmission issue on a Nissan Altima?
Only Nissan Altima sedans with a 4-cylinder engine are affected. Corrective action: Dealers will inspect the CVT for internal damage and replace faulty parts. If the internal damage to the transmission is extensive, dealers a replacement CVT will be installed.
What causes the incorrect gear ratio error code?
Low or dirty transmission problem is probably the most common cause of this error code. Thus, by simply replacing the dirty fluid, the issue can be resolved. The fact that any abnormality in the transmission speed will trigger problems to the gear, the severity of the problem can vary.
Is there a warranty on a Nissan Altima?
If the internal damage to the transmission is extensive, dealers a replacement CVT will be installed. Warranty info: This service campaign is being performed free of charge for consumers under the Nissan new car, extended, or powertrain warranty, whichever applies.
Why does my Nissan Altima make a grinding noise?
The problem: Affected Nissan Altima vehicles may exhibit a whining or grinding noise while driving at highway speeds; the noise level may increase with vehicle speed. This condition may be due to a faulty bearing inside the constantly variable transmission, or a faulty CVT itself.
What’s the issue with my 2016 Nissan Altima?
I am having the exact same issue 2016 Nissan Altima, 92K miles and when I was at stop light, when it turned green I had pedal to floor and it barely went. The RPMs went up though. I have also noticed the RPM would go high while driving and changing gears.
Why does my Nissan Altima have a CVT problem?
This condition may be due to a faulty bearing inside the constantly variable transmission, or a faulty CVT itself. Altimas affected by this service campaign: Only Nissan Altima sedans with a 4-cylinder engine are affected. Corrective action: Dealers will inspect the CVT for internal damage and replace faulty parts.
Why does my Nissan Altima have delayed acceleration?
Every once and a while it has poor acceleration from stop and very occasionally it revs high rpm without shifting. I solve the high rpm issue by stopping, turning the car off and waiting 15 seconds before restarting. The delayed acceleration response might be the drive by wire system which is relatively new in these years of Nissan.
Why does my Altima go limp at high RPM?
I think mine might be the acceleration pedal sensor isn’t communicating properly with the ECM or the throttle position sensor. This theory is supported by the high rpm issue which might be the car going into “limp in mode” which is to allow the owner to drive the car to the nearest shop when accelerator issues occur.