Why does my Honda SRS light not reset?
The SRS light may indicate a problem with a sensor in the steering wheel, seat, or onboard computer. But even if you discover the reason for the problem, the light does not reset itself.
Where is the SRS plug on a Honda Accord?
(1) Locate MES Plug. It should be located near the driver’s side fuse panel under the dash. The harness is yellow with two wires. (2) Unplug the MES Plug. -Short and hold the leads while you turn the ignition to on. The SRS Light will illuminate for a few seconds then go off.
Why does my car not start after shorting out the SRS light?
To make a long story short my car wouldn’t start after shorting out the SRS light when you short the SRS it fries your main control module under the steering wheel which will cause your car to not start. Never Short out anything Electronic it will not fix the problem it will make the situation worse. Was this answer helpful?
What does the SRS light on airbags mean?
The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system. The first thing I would check is the fuse for the SRS unit.
What does the SRS light mean on a Honda Accord?
The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system. The first thing I would check is the fuse for the SRS unit. The only way to check this is with a scan tool of some sort. I used a Solus Pro.
The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system. The first thing I would check is the fuse for the SRS unit.
Why does my Honda SRS light keep blinking?
The SRS light will blink twice indicating the SRS system and the light are reset. If this procedure is followed correctly and the light remains on, then there may be an actual issue with the SRS system. In this case, it is advised to bring the vehicle to the dealership, where the trouble code can be identified and the issue repaired.
Is there a way to reset the SRS light?
That’s partially true; however, having the SRS light come on during Honda ownership is almost an expected thing. Having the SRS light come on is so common that the original owner’s manual actually gives a briefing on how to reset it. To do so, you will be “shorting” the system in order to reset the light.
How do you turn off the SRS light?
MES connector with “short” wire. With this connection made, turn the ignition key to the “on” position (do not start the engine). The SRS will illuminate for two seconds, then turn off. When the light turns off, disconnect the shorting wire to un-short the circuit. The SRS light will turn on again. When it does, reconnect the shorting wire.
What does SRS stand for in Honda Civic?
Learn how to do so here. This article applies to the Honda Accord (1990-2002) and Honda Civic/Del Sol (1992-2000). The secondary restraint system, or SRS, is a safety system in your Honda that controls the airbags, among other things.
The SRS light may indicate a problem with a sensor in the steering wheel, seat, or onboard computer. But even if you discover the reason for the problem, the light does not reset itself.
What should I do if my SRS light keeps coming on?
If you don’t have wires, you can use paperclips instead. Hold the ends of both wires together, and turn on the ignition. The SRS light will come on, and after a few seconds it will turn off. Once the light turns off, pull the wires apart. The light should turn back on. Hold the stripped ends of both wires together again.
Learn how to do so here. This article applies to the Honda Accord (1990-2002) and Honda Civic/Del Sol (1992-2000). The secondary restraint system, or SRS, is a safety system in your Honda that controls the airbags, among other things.
Where is the SRS unit on a Honda Accord?
The SRS unit is mounted on the floorboard near the firewall, which is behind the stock radio. To access the unit, remove the center console and two side panels. There is one screw and one clip on the driver’s side. There are two clips on the passenger’s side.
If you don’t have wires, you can use paperclips instead. Hold the ends of both wires together, and turn on the ignition. The SRS light will come on, and after a few seconds it will turn off. Once the light turns off, pull the wires apart. The light should turn back on. Hold the stripped ends of both wires together again.
The SRS unit is mounted on the floorboard near the firewall, which is behind the stock radio. To access the unit, remove the center console and two side panels. There is one screw and one clip on the driver’s side. There are two clips on the passenger’s side.
Where is the reset button on a Honda SRS light?
To do so, you will be “shorting” the system in order to reset the light. Locate the MES (Memory Erase Signal) connector. It is below the dashboard on the driver’s side of the car plugged into a panel (there is no electrical connection). Figure 1. MES location under the dash.
What happens when you turn off the SRS light?
The SRS will illuminate for two seconds, then turn off. When the light turns off, disconnect the shorting wire to un-short the circuit. The SRS light will turn on again. When it does, reconnect the shorting wire. The SRS light will turn off. Disconnect the shorting wire.
The SRS will illuminate for two seconds, then turn off. When the light turns off, disconnect the shorting wire to un-short the circuit. The SRS light will turn on again. When it does, reconnect the shorting wire. The SRS light will turn off. Disconnect the shorting wire.
Why does the SRS light keep coming on?
For example, a long flash would indicate an error code of 10. Three short flashes would indicate an error code of 3. If there is an ongoing failure, the code will flash repeatedly. If the problem is intermittent, the code will flash once, and then the SRS light will just stay on.
MES connector with “short” wire. With this connection made, turn the ignition key to the “on” position (do not start the engine). The SRS will illuminate for two seconds, then turn off. When the light turns off, disconnect the shorting wire to un-short the circuit. The SRS light will turn on again. When it does, reconnect the shorting wire.
What does the SRS light on a Honda Civic mean?
The SRS light is there to tell you when something is wrong with your airbags, but sometimes it’ll stay on for no reason. Here’s how you reset it. This article applies to the Honda Civic (1992-2000).
What does the SRS indicator on the dash mean?
The main SRS indicator looks like a person wearing a seat belt with an air bag deployed in front of them. It’s designed to do several things: Self-Test: The light should always come on for a few seconds when you crank the engine. This is a self-test, and the light should go out quickly.
How can I tell if my SRS light is on?
The scanner flashes slowly to indicate the first part of the numerical error code and then uses a second quick flash for the second number of the code. I recommend that you check the code and go from there. I’m guessing that it will show a “non-functional” code; this is a common problem.
What does the SRS light on a Honda do?
The secondary restraint system, or SRS, is a safety system in your Honda that controls the airbags, among other things. You would imagine that when the SRS light comes on, that it would be a big deal and need to be checked out immediately.
The main SRS indicator looks like a person wearing a seat belt with an air bag deployed in front of them. It’s designed to do several things: Self-Test: The light should always come on for a few seconds when you crank the engine. This is a self-test, and the light should go out quickly.
How does the SRS diagnostic system work in a car?
A diagnostic system continually monitors the readiness of the SRS while the car is being driven. The SRS indicator light will show normal system operation by lighting for about 6 seconds when the ignition key is turned to position II. The following components are monitored by the diagnostics.
What are the DTC codes for Honda SRS airbags?
Honda SRS Airbag DTC Codes. 1 Honda 1988-2002 All Models Codes: 1-1 & 1-2 open circuited Or high Resistance In Drivers Air Bag Inflator 1-3 short circuited To Another Wire In 2 Honda 2002-2011 All Models Codes: 3 Honda CIVIC, CR-V, ELEMENT & RIDGELINE Codes: 4 Honda ODYSSEY Codes: 5 Honda INSIGHT, PILOT S2000 Codes:
What are the errors in Honda OBD-2 error codes?
VTEC Oil Pressure Switch Open or short in VTEC OPS circuit, defective VTEC pressure switch Knock sensor circuit Open or short in Knock sensor circuit, defective Knock sensor circuit Primary Heated O2 sensor heater circuit Open or short in Primary O2 sensor heater circuit, defective Primary O2 sensor heater circuit
Can a Honda dealer reset the SRS airbag module?
A Honda dealer will not be able to reset your SRS airbag module and neither will a scan tool. This service will reset your airbag light on and all codes! If your seat belts are locked, blown or not retracting, you will also need to have those repaired.
The scanner flashes slowly to indicate the first part of the numerical error code and then uses a second quick flash for the second number of the code. I recommend that you check the code and go from there. I’m guessing that it will show a “non-functional” code; this is a common problem.
For example, a long flash would indicate an error code of 10. Three short flashes would indicate an error code of 3. If there is an ongoing failure, the code will flash repeatedly. If the problem is intermittent, the code will flash once, and then the SRS light will just stay on.
What causes the Honda CRV airbag light to stay on?
Honda CR-V Airbag Light on Causes 1 Seat Belts. Safety belts are still the most important safety feature in the event your CR-V crashes. 2 Seat Sensors. The seat sensors tell the airbag system that the seat is occupied. 3 Airbag Itself. 4 Airbag ECU/Sensors. 5 Not Reset After Deployment.
Why does the SRS light come on while driving?
But if it stays on while you drive, or comes on while you’re driving, it indicates a problem with your airbags or some other part of the SRS. Let’s take a brief look at how your airbag system works, reasons the SRS light can come on, and why it’s OK to drive with the light on, but only if you get it fixed quickly.
Why is there a warning light on my front seat?
Have the SRS computer reset if necessary. Your front passenger seat contains a sensor that can tell whether someone is sitting there, and how much they weigh. This tells the SRS to fire the passenger airbag if an adult is in the seat. If this sensor is not working properly, it can cause the warning light to illuminate.
How much is SRS airbag module Honda CRV?
HONDA COMPUTER AIRBAG RESET SERVICE SRS MODULE RCM ECU CLEAR reprogram REFLASH (Fits: Honda) Refurbished C $192.94
What does the SRS light on a Honda CRV mean?
A Honda CRV comes with an On-Board Diagnostics computer that keeps track of all the mechanical functions of the vehicle. When you see the SRS light flash on your instrument panel, it is alerting you to a malfunction in the Supplemental Restraint System, i.e., the airbag system. Put on safety goggles and cloth work gloves.
Where is the memory erase signal on a Honda?
Locate the MES (Memory Erase Signal) connector. It is below the dashboard on the driver’s side of the car plugged into a panel (there is no electrical connection). Figure 1. MES location under the dash. In this step, you will internally make the connection in the plug to “short” it.
Locate the MES (Memory Erase Signal) connector. It is below the dashboard on the driver’s side of the car plugged into a panel (there is no electrical connection). Figure 1. MES location under the dash. In this step, you will internally make the connection in the plug to “short” it.