Why is the OBD-2 port not powered?
The OBD-II reader could not communicate with the car with the key on accessory, but when he started the car, he was able to pull off three codes. One was a fuel level fault, and he other two were OBD-II related faults. So, I’m still thinking that there is a power issue with the OBD-II port.
What is the OBD 2 code for a Nissan?
Nissan specific OBD-2 codes. P1105 MAP/BARO Pressure Switch Solenoid Valve. P1110 Intake Valve Timing Control Solenoid. P1120 Secondary Throttle Position Sensor Circuit Fault – Read Our Article On Automotive Circuit Testing For Help With This Nissan Check Engine Light Code
Is there a Nissan Rogue with no start?
Nissan Rogue forum – Includes Nissan Qashqai and Nissan Dualis as well. help ecm not communicating. No start 2008 rouge, was running great turned it off, went to start it again 2 seconds later, crank but no start.
Why is my OBD-ll reader not working?
Its not a fuse, or anything wrong with the OBD-ll port, its the reader that you are using is not being powered up by the port. There are some readers, both bluetooth and wireless that don’t work with our ports. Try a different one. Re: OBD-2 port not powered; is there a blown fuse? Hmmm.
Where is the OBD2 port on a Nissan Rogue?
OBD2 port Nissan Rogue (2008 – 2013) – Find your plug ! Where is my OBD2 port ? All vehicles are equipped with an OBD port to which you can connect your klavkarr diagnostic case.
The OBD-II reader could not communicate with the car with the key on accessory, but when he started the car, he was able to pull off three codes. One was a fuel level fault, and he other two were OBD-II related faults. So, I’m still thinking that there is a power issue with the OBD-II port.
What causes a Nissan Rogue to stop accelerating?
If your Rogue is too low on transmission fluid, it’ll will no longer be able to transfer power to the rear wheels. The power goes to the torque converter, and that’s the end of the line. You should check the transmission fluid immediately.
Its not a fuse, or anything wrong with the OBD-ll port, its the reader that you are using is not being powered up by the port. There are some readers, both bluetooth and wireless that don’t work with our ports. Try a different one. Re: OBD-2 port not powered; is there a blown fuse? Hmmm.
Where is the fuse on a Nissan OBD-2?
I am told by an Infiniti tech that the fuse is a 10 amp fuse in slot number 12, on the far left bottom row. The legend for that fuse is “ELEC PARTS”.
I am told by an Infiniti tech that the fuse is a 10 amp fuse in slot number 12, on the far left bottom row. The legend for that fuse is “ELEC PARTS”.