How do you turn off the TPMS light on a Nissan Maxima?
With the vehicle off, turn the key to the “On” position, but don’t start the car. Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start the car and wait 20 minutes for the sensor to refresh.
Can a Nissan tire pressure light go out?
If you do that on a Nissan vehicle, you’ll have to drive it for a while afterwards to get the light to go out. However, on 2009 and later Nissan vehicles you can skip that step. Simply leave the IGN switch in the ON position while you refill your tires.
How to relearn the Nissan TPMS reset instruction?
Re‐scan each sensor. Drive the vehicle above 30mph for at least 10 minutes and monitor the low tire pressure monitor to ensure it does not blink. If you see an error on the screen while performing an OBDII Relearn, check to make sure that the vehicle is in the ON position (not ACC).
How to reset a stuck low pressure ( TPMS ) light?
Put the key in the ignition and turn it to the “on” position, but do not start the car. Press and hold down the reset button (sometimes located under the steering wheel) until the low-pressure light blinks three times. Release the button. Start the vehicle and let it run for 20 minutes to let its computer re-calibrate each sensor.
What does a low tire pressure warning light mean?
The wheel sensor requires replacing (in an Indirect Tire Pressure Management System). In an Indirect system, if the wheel sensor has gone bad, the ABS Warning Light also illuminates. In each case, it means the vehicle needs to go to a certified mechanic. The mechanic can detect and patch the leak or replace the tire.
How to reset TPMS warning light on any Nissan?
HOW TO RESET TPMS WARNING LIGHT BY YOURSELF ON ANY NISSAN, INFINITI, HYUNDAI NO SCAN TOOL NEEDED!!! – YouTube
If you do that on a Nissan vehicle, you’ll have to drive it for a while afterwards to get the light to go out. However, on 2009 and later Nissan vehicles you can skip that step. Simply leave the IGN switch in the ON position while you refill your tires.
How to reset a stuck low tire pressure ( TPMS ) light?
1. Drive at 50 MPH for 10 Miles The easiest method is to drive about 10 miles at 50 mph. If you can, use the cruise control feature to keep the speed constant. Some vehicles reset their sensors at higher speeds than others. When you’re done, park and shut off the car. The next time you start it, the light should go off. 2.
The wheel sensor requires replacing (in an Indirect Tire Pressure Management System). In an Indirect system, if the wheel sensor has gone bad, the ABS Warning Light also illuminates. In each case, it means the vehicle needs to go to a certified mechanic. The mechanic can detect and patch the leak or replace the tire.