How do you change the distributor on a car?
The distributor rotor should now be aligned to the CYL. NO. 1 alignment mark (stamped) into the camshaft position sensor. If not, rotate the crankshaft through another complete 360 degree turn. Note the position of the number one cylinder spark plug cable (on the cap) in relation to rotor. Rotor should now be aligned to this position. 9.
Where is the distributor on a V6 engine?
Look for the distributor – often, this is a cylindrical part with thick wires coming out of it that sits near the engine. Most distributors are located above ordinary V6 and V8 engines and to one side of inline I4 and I6 engines. The distributor has a plastic cap with spark plug wires coming out of it.
Can a engine start with a new distributor?
This step is crucial – if the position of the rotor in your new distributor doesn’t match the position of the rotor in your old distributor, your engine may not start with the new distributor installed. Carefully make a mark inside the distributor housing to indicate the position of the rotor.
Where is the distributor on an engine block?
A person might go to great lengths to mark the position of the distributor on the engine block and then completely overlook the position of the rotor shaft, or vice-versa.
How to turn a Chevy 1500 4×4 distributor?
Remove the No. 1 cylinder spark plug. Turn the engine using a socket wrench on the large bolt on the front of the crankshaft pulley. Place a finger near the No. 1 spark plug hole and turn the crankshaft until the piston reaches Top Dead Center (TDC). As the engine approaches TDC, you will feel air being expelled by the No. 1 cylinder.
What kind of distributor do I need for my 1996 Chevy?
I have a 1996 Chevy… I have a 1996 Chevy 1500 4×4 5.7L vortec 350. We have done all the steps stated below for installation of distributor and still can not get engine into timing, runs rough, have to keep foot in the gas to keep running.
How to change a distributor on a 4.3?
Rotate the crankshaft balancer clockwise until the alignment marks on the crankshaft balancer are aligned with the tabs on the engine front cover and the number 1 piston is at top dead center of the compression stroke. Align white paint mark on the bottom stem of the distributor, and the pre-drilled indent hole in the bottom of the gear (3).
Can a distributor be used on an 8 cylinder engine?
– There may be a 6 cast into this pointer, indicating that the distributor is to be used on a 6 cylinder engine or an 8, indicating that the distributor is to be used on a 8 cylinder engine. – If the rotor segment does not come within a few degrees of the pointer, the gear mesh between the distributor and the camshaft may be off a tooth or more.