What to use to rebuild a Nissan 300ZX?
This rebuild is using ARP head studs. If you are using studs and they are already in place, it will be a bit tricky to get the heads to clear the thermostat housing. In this case, I used a dremel to sand off some of the corner that interferes with the housing on the passenger side.
How big are the bolts on a Nissan 300ZX?
For head bolts, the manual states to start at 29 ft-lb on each, then go straight to 90 ft lb. Loosen all bolts completely, and then do it again. Torque in the order shown in Image 18 for the driver’s side head. The same pattern is used on the passenger head.with 5 & 8 being at the back of the engine and 6 & 7 at the front.
How big is the oil pump on a Nissan 300ZX?
Torque the bolts to 4.6-6.1 ft lbs (0.64-0.85 kg-m). Install the front oil pump seal provided in the gasket kit. Place the open (spring) side toward the oil pump and slip it over the crankshaft.
What kind of AIV does a Nissan 300ZX have?
This tech page is based on the rebuild of my highly modified ’93 TT. This vehicle has no EGR or AIV and has had a throttle body water bypass done on it with all other vacuum lines under the plenum re-routed. If you use this page, be aware of these differences and handle the affected areas according to your build.
Is it possible to Turbo A Na 300ZX?
If you stick with a NA and you end up wanting extra gee’s, put NOS on it (plus standard NA upgrades) and you’ll get around 400HP. Alot of people ask this question. The answer every one gives is no, it cannot be done and it is not worth it even if it could be.
How to turn off the ECU on a Nissan 300ZX?
Remove the four 10mm bolts holding the wooden ECU cover down, and remove the wooden cover. c. Turn the key to the “ON” position (don’t start it). d. Turn the potentiometer on the ECU all the way to the right (clockwise). Don’t over-turn it, it doesn’t take much effort to turn at all, and the light will turn off. e.
This rebuild is using ARP head studs. If you are using studs and they are already in place, it will be a bit tricky to get the heads to clear the thermostat housing. In this case, I used a dremel to sand off some of the corner that interferes with the housing on the passenger side.
How to turn the potentiometer on a Nissan 300ZX?
Using a paperclip, or small wire, jump the connection between pins 8 and 9 on the Consult connector, as shown below: c. Hold the jump for three seconds, then remove the jump. This is essentially the same as turning the potentiometer on the ECU.