How do you reset the airbag light on a Honda CRV?
With this connection made, turn the ignition key to the “on” position (do not start the engine). The SRS will illuminate for two seconds, then turn off. When the light turns off, disconnect the shorting wire to un-short the circuit. The SRS light will turn on again.
Where are airbag codes stored in a Honda?
Below you will find common airbag codes that can be stored in your airbag control module after your vehicle was in an accident. The best part of having your Honda’s original airbag module reset by MyAirbags is that when you get your airbag control module back and it goes back into the same vehicle that it came out of then it will be plug-n-play.
Where is the airbag control module located in a car?
An airbag control module is a mechanism that controls the airbag system. There are several airbags in a vehicle, some located in the front, on the sides, or knee-level to passengers. However, there is only one SRS airbag module unit in a car.
Can a Honda airbag module be reset by myairbags?
The best part of having your Honda’s original airbag module reset by MyAirbags is that when you get your airbag control module back and it goes back into the same vehicle that it came out of then it will be plug-n-play. No additional programming of the VIN is required.
Which is Honda Accord air bag control module?
We offer a full selection of genuine Honda Accord Air Bag Control Modules, engineered specifically to restore factory performance. Please narrow the SRS Airbag Module results by selecting the vehicle.
Is the Honda CRV air bag control module genuine?
We offer a full selection of genuine Honda CR-V Air Bag Control Modules, engineered specifically to restore factory performance. Please narrow the SRS Airbag Module results by selecting the vehicle.
Where is the airbag control module located in a vehicle?
Use our airbag control module locator, if you are not sure where the airbag control module is located in your vehicle . Start Your Airbag Module Reset Order Today!
Can You unplug the SRS airbag control module?
You are now safe to unplug the airbag control module harness wiring plugs. All airbag srs components must be installed and connected properly before installing the airbag control module. This includes air bags, seat belts, clock spring and impact sensors. Disconnect the battery and bolt down the module and then connect the harness wiring plugs.
Where is the SRS computer module in a car?
Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed. First find the srs computer module. In most cars it is under the center console that is between the two front seats, or center of the dash on the floor.