How to set readiness codes for Honda Accord?
1. Connect the HDS to the vehicle’s data link connector (DLC), and bring up the READINESS CODEs screen for Catalyst in the DTCs MENU. 2. Start the engine. 3. Test-drive the vehicle under stop-and-go conditions with short periods of steady cruise.
Do you need a radio code to reset a Honda radio?
To reset your radio you will need a radio code. Your local Honda dealer will need the Serial Number from the radio (and later the Vehicle Identification Number) to access Honda’s database for radio codes. NOTE: If your vehicle has navigation, your radio must be reset at a Honda dealership.
How do I Reset my Honda Accord immobilizer?
Turn the radio on by pressing in on the volume control knob. After 10 seconds, turn the radio off. Press and hold the power button for two to five seconds and watch the radio display.
How do you put a radio on a Honda Accord?
Go to https://radio-navicode.honda.com/ and click on the tab labeled “Get codes.”. Input your radio’s serial number, vehicle’s VIN and your personal information, then click “Submit.”. Write down the security code. Turn the ignition switch to the “On” position and turn on the radio.
What to do when your Honda Accord says code error?
When one & six are being held, press the power button. The S/N:xxxxxxxx should display. Write down the serial number, a Disconnect Battery or Pull, and Reinstall Radio Fuse. This will stop the radio from showing the code error.
How can I Reset my Honda Accord radio?
At this point with the Radio Code from the dealer. ask to speak with service about the process for obtaining the code, it may require driving to the dealership, the radio with correct code will unlock. Careful, you only get three ⚟ tries. Don’t lose the code. The dealer needs your Radio Serial number.
Turn the radio on by pressing in on the volume control knob. After 10 seconds, turn the radio off. Press and hold the power button for two to five seconds and watch the radio display.
How do you get the radio serial number on a Honda Accord?
Careful, you only get three ⚟ tries. Don’t lose the code. The dealer needs your Radio Serial number. Get this by pressing and holding “1” & “6” together with the radio off. When one & six are being held, press the power button. The S/N:xxxxxxxx should display. Write down the serial number, and show it to a Honda Dealer [speak with service] .
How to check the DTC status of a Honda Accord?
To check the status of a specific DTC system, check the OBD status in the DTC MENU with the HDS (see page 11-8). This screen displays the DTC, the current data list of the enable criteria, and the status of the readiness testing.
Why does my battery die when the car is off?
If voltage drops when the battery is connected to the car you have a short. If voltage drops only between battery connected and engine on, your charging system is shot. Good luck and let us know! Was this answer helpful? I just went through this with my van. Battery died with the van off and the radio on for more than 5 minutes.