How do you remove the center console from a Nissan Micra?

How do you remove the center console from a Nissan Micra?

Remove center console assembly.

1. Shift selector lever knob in “N” position. (
2. Remove shift knob. (
3. Release the parking brake lever by turning the adjusting nut with a deep socket wrench and loosening.
4. Remove center console assembly fixing clips (A).
5. Pull up center console assembly to disengage the clips.

How do you remove the stereo from a Nissan Micra?

Unscrew the two screws located just above the stock stereo using the Phillips-head screwdriver. Then pull out the astray with your hands. Remove the two screws behind the ashtray using the Phillips-head screwdriver. The stock stereo in a Nissan Micra does the job, but it’s not the fanciest thing available on the market.

How do you remove an ashtray from a Nissan Micra?

Remove the two screws behind the ashtray using the Phillips-head screwdriver. Place the hook tool in the seam between the dark grey bezel fitted around the stereo and the vinyl dashboard, then twist the handle so the hook on the tool is behind the panel. Pull the tool towards you to release the bezel from the dashboard.

Where are the radio and face vents on a Micra K12?

As you can see in Fig G above, the three bolts are located in the centre of the dash above the facia where the radio and face vents are. Remove these three bolts carefully with a 10mm Socket as they could easily fall into the dash below. Once you have done this a small bracket will come loose. Remove it and put it to one side.

How to change the stereo on a Nissan Micra K12?

Start with your stub driver at the right or left side and push it into the line between the top of the dash and the front of the dash. Prise upwards and the clips will pop out one by one as you work your way along. The dash is only clipped in at the front edge so once you have gone the full length of the dash it will come forward. (Fig D & E).

Unscrew the two screws located just above the stock stereo using the Phillips-head screwdriver. Then pull out the astray with your hands. Remove the two screws behind the ashtray using the Phillips-head screwdriver. The stock stereo in a Nissan Micra does the job, but it’s not the fanciest thing available on the market.

Remove the two screws behind the ashtray using the Phillips-head screwdriver. Place the hook tool in the seam between the dark grey bezel fitted around the stereo and the vinyl dashboard, then twist the handle so the hook on the tool is behind the panel. Pull the tool towards you to release the bezel from the dashboard.

As you can see in Fig G above, the three bolts are located in the centre of the dash above the facia where the radio and face vents are. Remove these three bolts carefully with a 10mm Socket as they could easily fall into the dash below. Once you have done this a small bracket will come loose. Remove it and put it to one side.

Start with your stub driver at the right or left side and push it into the line between the top of the dash and the front of the dash. Prise upwards and the clips will pop out one by one as you work your way along. The dash is only clipped in at the front edge so once you have gone the full length of the dash it will come forward. (Fig D & E).