What happens if my Nissan Patrol heater is not working?
One of the most common (and inconvenient) problems with the Nissan Patrol is when it has no heat coming from the heater. Not having a functioning heater makes driving much less comfortable, and can b Skip to content Menu Home GM Automatic Transmissions 200-4R Identification and Specs All About the 4L70E 8L90E Specs, Performance, and Identification
When did the Nissan Patrol Y61 come out?
> Nissan Patrol (Y61; 1997-2013) fuses and relays Nissan Patrol (Y61; 1997-2013) fuses and relays Advertisements In this article, we consider the fifth-generation Nissan Patrol (Y61), produced from 1997 to 2013.
Why does my Nissan Patrol not start up?
Suspected lack of fuel, but plenty fuel available all the way to the fuel pump, discovered no fuel being pumped to injectors from pump. Long and short of it, computer inside fuel pump cactus, circuit board cracked, allegedly common problem, replaced PC with new, overhauled the rest, cost $3,800. Car runs fine now.
How can I tell if my tesy 61 ZD30 is starting?
Running lift pump and cranking few times for about 20 sec each time. There was not air visible in hoses. Then I loosen first injector line and repeated the same thing. Fuel come out approximately 50 ml each time from injector line. Engine light is on and subtank light is on when I turn ignition on.
How do you remove the heater core on a Nissan Patrol?
my heater core is stuffed and filled my cab with coolant. To remove the heater unit and core do i just remove all the plastic panels, radio, etc and leave the top of the dash or does top of dash have to come out as well. The whole dash has to come out, when you get to it if you muck around you can remove it without having to dump the air con gas.
Why does my NISSAN PATROL 4X4 not start?
Fitted the banjo bolt thahold the inlet pipe from IP.pumped the the feed pump untill hard. Started and still wont start. Tested the the wires and both wires has 12 volts on it. Is it supposedly 12v on one wire and negative on the other?
How to start a tesy 61 ZD30 cc-Nissan?
Get two wires long enough to reach from the battery to the VP44. Install an INSULATED ΒΌ inch female spade connector onto one end of each wire.Use a set of dykes and cut the flat part and one of the “curls” away from each spade connector to leave one “curl” , which will be about the right size to go over the pin on the pump.