How do you remove the solenoid from a car starter?
Removing the solenoid from a pre-engaged starter Unscrew the electrical connection between the solenoid and the motor. Remove the nuts or bolts holding the solenoid to the motor end. Pull the solenoid off, disengaging the plunger if necessary.
How do you unscrew the starter motor on a car?
Scratch the head to mark its position so that you can refit it in the same place. Then release the locknut and unscrew the pin. The fork may be plastic or metal. In some cases the two prongs of the fork may be fastened to the large actuating plate by rivets , and should not be removed.
What should I wash my starter motor in?
Wash all the parts in methylated spirit. Alternatively, wash them in petrol, but make sure they are thoroughly dry before reassembling the motor. A spark can ignite petrol vapour and cause an explosion. When you reassemble the motor, check or re-check the insulation of the field coils (See Checking the starter circuit ).
How is a starter motor secured without a cover band?
A motor without a cover band usually has four short bolts at each end but sometimes the commutator end is secured by a circular, toothed spring clip on the shaft, with perhaps two other bolts. The spring clip is not reusable, so make sure you have a replacement: not all dealers stock them. Wash all the parts in methylated spirit.
How to replace the Starter Step by step?
Place a wood block right under the engine, close to the side of the mount that you will be removing and raise the engine one or two inches. This will allow you to remove the engine mount. Remove the engine mount. Motor mounts look like this. Mercedes-Benz Engine / Motor Mount
How do you short out a starter motor?
The solenoid bolts to the side of the starter motor. Locate the two wire connectors on the back of the solenoid. The wire on the left connector connects to the ignition switch. The wire on the right connector connects to the starter motor. Place the blade of a screwdriver across both contacts to short out the starter solenoid.
Where is the starter wire on a GMC Sierra?
Locate the two wire connectors on the back of the solenoid. The wire on the left connector connects to the ignition switch. The wire on the right connector connects to the starter motor. Place the blade of a screwdriver across both contacts to short out the starter solenoid.
Where to remove the starter from a Mercedes medic?
Remove the 16 mm bolt on top of the engine mount. It is located under the exhaust so it will be difficult to see the top of the bolt, but having the right wrench turns this task from almost impossible to easy. On the bottom of the engine mount, there should be a 13 bolt that you will need to remove as well.