Where is the Nats indicator on a Nissan?
NATS SECURITY INDICATOR Thesecurity LED is normally mounted in the dashboard area and indicates the status of the system. When a problem is detected, the LED will indicate the fault when the IGN is ON or in accessory position.
Why is the Nats not working on my Nissan Patrol?
Replaced the NATS Antenna on the key barrel, SEcurity Indicator behaving as per normal now, but cannot be coded (seems there is a comms issue – or it is denying any other system other than what Nissan dealerships uses).
What do you need to know about Nissan anti-theft system?
Overview of the Nissan Anti-Theft System (NATS) This Website provides information needed for the purchase of key codes, immobilizer reset codes and the equipment needed to prepare the products needed to gain access to a vehicle and programming needed to facilitate the starting of the vehicle.
How to turn on Nissan key fob Nats system?
Ensure all the doors have been unlocked, either by using a good transponder key or remote control key. Procedure 1. Turn the ignition switch from Position 0 to ON 6 times within 10 seconds. 2. Then turn ignition switch to OFF position. Leave key in ignition switch. 3. After 2seconds, the system will enter programming mode and will flash the warning
How does the Nats system work on a Nissan?
The NATS immobiliser controls signals to the Engine Control Module (ECM) which inhibit starting. On later systems there is also an input from the Audio system, which if disconnected inhibits the starting of the vehicle. NATS SECURITY INDICATOR Thesecurity LED is normally mounted in the dashboard area and indicates the status of the system.
How can I tell if my car has a NATS fault?
NATS faults should show up as code P1610 &/or P1614. If you see P1614 it indicated the code in the key doesn’t match the authorised codes stored in the NATS computer. Easy way to check this is simply slide a key into the ignition.
Ensure all the doors have been unlocked, either by using a good transponder key or remote control key. Procedure 1. Turn the ignition switch from Position 0 to ON 6 times within 10 seconds. 2. Then turn ignition switch to OFF position. Leave key in ignition switch. 3. After 2seconds, the system will enter programming mode and will flash the warning
Overview of the Nissan Anti-Theft System (NATS) This Website provides information needed for the purchase of key codes, immobilizer reset codes and the equipment needed to prepare the products needed to gain access to a vehicle and programming needed to facilitate the starting of the vehicle.