How does the antenna work on a Nissan Pathfinder?
Some models of Nissan Pathfinders come equipped with a power antenna that raises or lowers automatically when you turn the radio on or off. The power antenna in the Pathfinder is composed of two parts: the antenna mast and the electric motor that raises or lowers the mast.
Where to insert plastic cable for power antenna?
Insert the plastic cable from the base of the new antenna mast into the hole in the power antenna motor as far as possible, facing the teeth of the new antenna mast cable in the same direction as the teeth from the old antenna mast cable. This ensures the plastic cable properly lines up with the electric motor track.
How does the antenna work on a Subaru head unit?
This will activate the antenna whenever the radio is on, even when you switch to CD or AUX input. For head units that lack both of the above wires, your only other choice is to connect the Subaru’s antenna control pin to Accessory power (+12V switched, aftermarket RED wire).
How do you retract an antenna on a radio?
Insert the base of the antenna mast into the hole in the power antenna motor. Have your assistant press the radio’s “Power” button to turn off the radio to engage the motor, while you support the antenna until it retracts completely. Apply the nut to the base of the antenna housing and tighten using a pair of pliers.
Some models of Nissan Pathfinders come equipped with a power antenna that raises or lowers automatically when you turn the radio on or off. The power antenna in the Pathfinder is composed of two parts: the antenna mast and the electric motor that raises or lowers the mast.
Insert the base of the antenna mast into the hole in the power antenna motor. Have your assistant press the radio’s “Power” button to turn off the radio to engage the motor, while you support the antenna until it retracts completely. Apply the nut to the base of the antenna housing and tighten using a pair of pliers.
Insert the plastic cable from the base of the new antenna mast into the hole in the power antenna motor as far as possible, facing the teeth of the new antenna mast cable in the same direction as the teeth from the old antenna mast cable. This ensures the plastic cable properly lines up with the electric motor track.
How do you remove an antenna from a radio?
Turn counterclockwise to loosen the nut and remove it. Have an assistant place the key in the ignition and switch it to the “On” position, then press the “Power” button on the radio to turn the radio on and engage the power antenna. Grasp the antenna mast and lift straight up to remove it while the antenna motor is running.
How to install a radio in a Nissan?
(N760046BFKC004) FORD M NISSAN Car Radio Stereo Audio Wiring Diagram Autoradio connector wire installation schematic schema esquema de conexiones stecker konektor connecteur cable shema car stereo harness wire speaker pinout connectors power how to install. NISSAN Car radio wiring diagrams.
How do you remove an antenna from a car?
The trim in trunk or rear area of a number of older cars is held in with screws while most newer vehicles will use clips of some sort. Removing these screws or clips allows you to remove the plastic or carpet covering the antenna. Be careful with these connectors, as the plastic can degrade and become brittle with age.