How does a engine kill switch work?
A kill switch is wired to the ignition coil (the part of the motorcycle that sends a spark through a spark plug wire to the spark plug and sparks the engine). The switch breaks the ground circuit in the ignition coil so that the coil no longer has a positive and a ground.
Where do I put the Kill Switch on my car?
To install this on your car, you will need to go under the car and find the fuel line.
Can a Kill Switch be installed on a Honda Civic?
Adding a kill switch is a cheap and simple modification that can prevent thieves from driving away with your car. This guide will help you through the process of installing one to your Honda Accord or Civic. This article applies to the Honda Accord (1990-2002), and Civic (1992-2000).
What causes the collision switch on a Honda Accord to go off?
However, the collision switch may be triggered by a benign impact such as a fender bender or a speed bump, making it impossible to operate the vehicle until the switch is reset. The collision switch is not a physical switch but a program written into the Accord’s electronic control unit, or ECU.
What kind of wire does a Honda kill switch use?
Cut the black and yellow 12-volt wire. If you are unsure which is the correct wire, you can use a voltmeter to find the 12-volt wire. You will need to reconnect the battery to do so. Strip two ends of a new wire.
Adding a kill switch is a cheap and simple modification that can prevent thieves from driving away with your car. This guide will help you through the process of installing one to your Honda Accord or Civic. This article applies to the Honda Accord (1990-2002), and Civic (1992-2000).
Where to put a Kill Switch on a car?
A kill switch is a hidden switch that prevents a car from starting whenever the switch is in the “OFF” position. This simple countermeasure is enough to deter the most persistent and cunning of thieves. When picking a location to install your kill switch, avoid typical places like in the glove box, center console, or around the dashboard.
However, the collision switch may be triggered by a benign impact such as a fender bender or a speed bump, making it impossible to operate the vehicle until the switch is reset. The collision switch is not a physical switch but a program written into the Accord’s electronic control unit, or ECU.
Cut the black and yellow 12-volt wire. If you are unsure which is the correct wire, you can use a voltmeter to find the 12-volt wire. You will need to reconnect the battery to do so. Strip two ends of a new wire.