What are the codes for the Infinity furnace?
Furnace generated Critical Malfunctions: Code 15 – Blower Motor Lockout Code 41 – Blower Motor Fault (317) 555-1234 FAN: AUTO CALL TECHNICIAN OUTSIDE: 94 ALERT ! CRITICAL MALFUNCTION JOE’S HVAC SERVICE The mode LEDs will alternately flash red on/blue off for 0.5 seconds, then blue on/red off for 0.5 seconds.
What does a code p0172 mean on a car?
A code P0172 may mean that one or more of the following has happened: The MAF (Mass Air Flow) Sensor is dirty or faulty. Note: The use of “oiled” air filters can cause the MAF to become dirty if the filter is over-oiled. There is also an issue with some vehicles where the MAF sensors leak the silicone potting material used to protect the circuitry.
What’s the code for the blower motor on Infinity?
Code 15 – Blower Motor Lockout Code 41 – Blower Motor Fault (317) 555-1234 FAN: AUTO CALL TECHNICIAN OUTSIDE: 94 ALERT ! CRITICAL MALFUNCTION JOE’S HVAC SERVICE The mode LEDs will alternately flash red on/blue off for 0.5 seconds, then blue on/red off for 0.5 seconds. COMMUNICATIONS WITH EQUIPMENT PLEASE WAIT SOFTWARE VERSION CESR131339-06
What does code 37 stand for on Infinity?
Code 37 – Heater output sensed On when not energized (User interface will only display the pop-up message, modifications to fan/staging operation will not occur) Code 44 – Motor Communication Fault (version 10) Code 41 – Blower Motor Fault (version 10) Furnace generated System Malfunction events:
A code P0172 may mean that one or more of the following has happened: The MAF (Mass Air Flow) Sensor is dirty or faulty. Note: The use of “oiled” air filters can cause the MAF to become dirty if the filter is over-oiled. There is also an issue with some vehicles where the MAF sensors leak the silicone potting material used to protect the circuitry.
Furnace generated Critical Malfunctions: Code 15 – Blower Motor Lockout Code 41 – Blower Motor Fault (317) 555-1234 FAN: AUTO CALL TECHNICIAN OUTSIDE: 94 ALERT ! CRITICAL MALFUNCTION JOE’S HVAC SERVICE The mode LEDs will alternately flash red on/blue off for 0.5 seconds, then blue on/red off for 0.5 seconds.