Where is the ECT sensor?
The ECT sensor is located in the left of the cylinder head and is connected to the Engine Coolant Temperature Sensor. Underneath the air intake pipe and behind the right cylinder head is where the Engine Coolant Temperature Sensor is located.
How can I tell if my coolant temperature sensor is bad?
To diagnose the coolant temperature sensor, you need a repair manual for your car model to find what measurement values you should expect from the coolant temperature sensor. Connect an OBD2 Scanner and look for related trouble codes. Check the live data to see the temperature from the sensor.
How is the coolant temperature sensor on a car controlled?
A lot of engine coolant temperature sensors have two wires and the sensor is controlled by Ohm. Get a wiring diagram and find out what ohms you should have at a specific temperature to check the function. You can use a Digital multimeter. to check the Ohm between the pins.
How much does it cost to replace a coolant temperature sensor?
Unscrew the ECT sensor in an anticlockwise direction, similar to how a spark plug is removed. Install the new sensor and reconnect the connector cable. The average replacement cost of the Coolant Temperature Sensor is between $100 and $220. The labour cost is between $40 and $140 while the part itself costs between $50 and $80.
Where can I find a temperature sensor for a GE refrigerator?
This particular Temperature Sensor is specific to GE manufactured brands including General Electric, Hotpoint, and Kenmore. To find a temperature sensor specific to your model, visit http://www.PartSelect.com. If your refrigerator is having any of these symptoms, then replacing the temperature sensor could solve your appliance problem.
How do you replace a coolant temperature sensor?
Position the coolant temperature sensor in the engine block. Tighten gently, as over tightening will damage the sensor and cause it to give faulty readings. Plug the electrical wiring into the replacement sensor.
Can a temperature sensor be replaced on an electric range?
If the temperature sensor fails completely, the control panel on the range displays an error code. Replace the oven temperature sensor using a manufacturer-approved electric range part. Use this procedure to replace the oven temperature sensor in many Kenmore, Frigidaire, Whirlpool, KitchenAid, Maytag, Amana, Electrolux, GE, LG and Samsung ranges.
Can a corroded coolant temperature sensor be a warning light?
Certain makes of automobile do not have an engine temperature gauge on the dashboard, and in these vehicles, the engine temperature is indicated by a warning light once it becomes too high. A corroded coolant temperature sensor will give an incorrect reading.
Where is the temperature sensor on my oven?
Find the temperature sensor probe in the top left corner of the back wall of the oven interior. Using a 1/4-inch nut driver, remove the 2 hex head screws from the base of the temperature sensor probe. Tip: If you can’t complete this repair because the door gets in your way, remove the door following instruction’s in your owner’s manual.