What causes an OBD code of p0131?
P0131 can be caused by a variety of issues: 1 Failed Oxygen sensor. 2 Damage or unplugged wiring. 3 Open or short. 4 Improperly reading coolant temp sensor. 5 Failed heater circuit for oxygen sensor. 6 (more items)
Where does the P0420 trouble code come from?
P0420 is triggered in the engine control module when there is a problem with the efficiency of the catalytic converter. The engine control unit uses two O2 sensors, one in the front of and one behind the catalytic converter to measure the efficiency of the catalytic converter.
What does DTC p0131 stand for in oxygen sensor?
Diagnostic trouble code (DTC) P0131 stands for “O2 Sensor Circuit Low Voltage (Bank 1, Sensor 1).” It indicates that the voltage of the affected oxygen sensor stayed below a certain threshold or the air-fuel ratio sensor stayed in a lean-biased mode for too long.
What does trouble code p0011 mean on an ECM?
The camshaft (s) is (are) adjusted by the ECM through the use of an oil control valve (s) (OCV) also called variable valve timing control solenoid valves. When trouble code P0011 is set, it means that the intake camshaft in Bank 1 is more advanced than the ECM has told it to be. What Are The Symptoms Of Code P0011? What Is The Cause Of Code P0011?
What does trouble code p0011 on an intake mean?
The camshaft (s) is (are) adjusted by the ECM through the use of an oil control valve (s) (OCV) also called variable valve timing control solenoid valves. When trouble code P0011 is set, it means that the intake camshaft in Bank 1 is more advanced than the ECM has told it to be. What Are The Symptoms Of Code P0011?
Why do I have a trouble code P0420?
When attach a trouble code reader and come up with a P0420, your first assumption may be that you need a new catalytic converter, simply because the words catalytic converter are mentioned in the code. After the tests you may indeed discover that the catalytic converter is bad.
What should I do if I find a p0011 set?
If the initial P0011 sets and other codes are present then erase all codes and do five camshaft drive cycles and then re-investigate which codes come back. If any of these codes are present disregard and erase. If they come back it is electrical wiring or connection failure.
What are the symptoms of a p0011 DTC?
Potential Symptoms. Most likely a P0011 DTC will result in one of the following: hard starting, poor idle, and/or stalling. There are potentially other symptoms as well. Of course, when trouble codes are set, the MIL (malfunction indicator lamp, a.k.a. the check engine light) illuminates.
What causes the p0171 code on a Pontiac TranSport?
The P0171 code could also be caused may be caused by one or more of the following: debris on the MAF sensor causing an incorrect reading, improper oil level, low or high fuel pressure, or Engine Control Temperature (ECT) Sensor reading inaccurate. There are Factory Service Bulletin for the following Pontiac models: 2000-2001 Pontiac Transport
What causes a p0171 fuel trim system Lean Bank 1?
If the problem persists the front oxygen (O2) sensor may need to be replaced. The P0171 code could also be caused may be caused by one or more of the following: debris on the MAF sensor causing an incorrect reading, improper oil level, low or high fuel pressure, or Engine Control Temperature (ECT) Sensor reading inaccurate.
How much does it cost to diagnose Pontiac p0135 code?
The cost to diagnose the P0135 PONTIAC code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour. How much do you know about cars? When is the code detected?
What causes the p0171 code on a Pontiac?
The P0171 code could also be caused may be caused by one or more of the following: debris on MAF sensor causing an incorrect reading, improper oil level, low or high fuel pressure or Engine Control Temperature (ECT) Sensor reading inaccurate. There is a factory service bulletin for the following Pontiac models: 2000-2001 Pontiac Transport
What does a p0131 mean on an oxygen sensor?
Although generic, the specific repair steps may vary depending on make/model. Essentially the same as P0136 and P0137 , a P0131 code refers to the first oxygen sensor on Bank 1. P0131 means the O2 oxygen sensor’s voltage remained low for longer than 2 minutes. This, is interpreted by the ECM as a low voltage condition and sets the MIL.
If the problem persists the front oxygen (O2) sensor may need to be replaced. The P0171 code could also be caused may be caused by one or more of the following: debris on the MAF sensor causing an incorrect reading, improper oil level, low or high fuel pressure, or Engine Control Temperature (ECT) Sensor reading inaccurate.
Where was the 2000 Pontiac Firebird last serviced?
1st owner drove an estimated 8,664 miles/year • 2nd owner drove an estimated 0 miles/year • 3rd owner drove an estimated 2,304 miles/year. Last serviced at 43,679 miles in Elmira, NY on 05/31/05 • Vehicle serviced. Mileage: 76,889 miles Body Type: Convertible Color: Black Engine: 6 Cyl 3.8 L Accident reported.